Subscribe to Our Youtube Channel
Related Manuals for Schaller Automation VISATRON
Summary of Contents for Schaller Automation VISATRON
- Page 1 Version 2.4, 02/2008 VISATRON Remote Indicator I VN/87plus OMD VN/93 OMD Operation Manual Part-No. 10 967 Part-No. 10 965...
- Page 2 Conditions of Sale The standard conditions of sale of SCHALLER AUTOMATION (current version) shall apply to all sales of VISATRON and connected products to any of our customers. Operation Manual Remote Indicator I, Ver.2.4, 20.02.2008...
- Page 3 SCHALLER AUTOMATION D – 66440 Blieskastel / Saarland / Germany / Industriering 14 / P.O. Box 1280 Tel [+49(0)6842508] [ ]– 0 / Fax [ ]-260 / eMail: info@schaller.de / www.schaller.de Industrielle Automationstechnik GmbH & Co. KG Safety instructions The Remote Indicator II is manufactured according to the high quality standard of SCHALLER AUTOMATION and passes the stringent factory tests.
- Page 4 D-66440 Blieskastel Tel.: 06842 / 508-0 Fax: 06842 / 508-260 declare on our own responsibility, that the product: Monitoring Device Kind of equipment: VISATRON Remote Indicator I Type-designation 10 965 Part-No.: is in compliance with following norms : EN 61000-4-2...
-
Page 5: Table Of Contents
SCHALLER AUTOMATION D – 66440 Blieskastel / Saarland / Germany / Industriering 14 / P.O. Box 1280 Tel [+49(0)6842508] [ ]– 0 / Fax [ ]-260 / eMail: info@schaller.de / www.schaller.de Industrielle Automationstechnik GmbH & Co. KG Table of Contents Introduction and functional overview ........ -
Page 6: Introduction And Functional Overview
It's also possible to reset 'Oil-Mist-Alams'. The device can be connected to VISATRON devices of series VN93 and VN87plus. It is possible to monitor the relative opacity and the state of one OMD device similar to the OMD display. The connection to the VN93 and VN87plus units is realized by a RS485 two-wire bus. -
Page 7: Installation Instructions
SCHALLER AUTOMATION D – 66440 Blieskastel / Saarland / Germany / Industriering 14 / P.O. Box 1280 Tel [+49(0)6842508] [ ]– 0 / Fax [ ]-260 / eMail: info@schaller.de / www.schaller.de Industrielle Automationstechnik GmbH & Co. KG 2 Installation instructions... -
Page 8: Electrical Installation
Connection of the power supply to the Remote Indicator II device. Figure 03: Terminator and cable entry on the bottom side of the VISATRON devices It is necessary to terminate the data link on both sides of the cable. In the Remote Indicator I a terminating resistor is already integrated. - Page 9 Table 01: Pin assignment and connection to VN93 or VN87plus The used data cable must be twisted pair and shielded. The total bus length is limited to 400 m. The grommet (see figure 03) at the VISATRON device is designed for cable diameter between 7,5 and 10,0 mm.
- Page 10 SCHALLER AUTOMATION D – 66440 Blieskastel / Saarland / Germany / Industriering 14 / P.O. Box 1280 Tel [+49(0)6842508] [ ]– 0 / Fax [ ]-260 / eMail: info@schaller.de / www.schaller.de Industrielle Automationstechnik GmbH & Co. KG Schematic Connection Diagram...
- Page 11 After display of the greeting, the following will be displayed: Figure 06: Ready Mode In case that serial RS485-connection between VISATRON Remote Indicator I and VISATRON OMD deviCe can not be established, the following message will be shown: Figure 07: Missing communication over RS485-interface Operation Manual Remote Indicator I, Ver.2.4, 20.02.2008...
-
Page 12: Functional Description
In the standard display (after the power-up and without pressing any button) the type of the connected VISATRON OMD device and the value of the measured opacity will be shown in the code-field and in the value-field, respectively as at the local display of the VISATRON OMD device. - Page 13 Industrielle Automationstechnik GmbH & Co. KG Buttons UP and DOWN Press the button 'UP' or 'Down' to enter the display mode of the VISATRON OMD device operating parmeters. The parameters are explained in the VISATRON OMD device manual on page 3.06.
-
Page 14: Maintenance Procedures
Regularly clean the surface of the panel with a soft, dry cloth. 5 Accessories Scope of supply are all components to connect a Remote Indicator I to one VISATRON OMD- System excluding the cable. The recommended cable can be ordered in steps of 10 m. -
Page 15: Technical Data
SCHALLER AUTOMATION D – 66440 Blieskastel / Saarland / Germany / Industriering 14 / P.O. Box 1280 Tel [+49(0)6842508] [ ]– 0 / Fax [ ]-260 / eMail: info@schaller.de / www.schaller.de Industrielle Automationstechnik GmbH & Co. KG 6 Technical data... -
Page 16: Service Addresses
80, Ag. Dimitriou Street 18545 Piraeus CHINA Phone-no. +30 - 2 -10 - 4 61 10 10 SCHALLER AUTOMATION -China Telefax-no.: +30 - 2 -10 - 4 61 75 19 Room 402 No.7 Building Person in charge: Mr. Chrisostomos Karkanis... - Page 17 D – 66440 Blieskastel / Saarland / Germany / Industriering 14 / P.O. Box 1280 Tel [+49(0)6842508] [ ]– 0 / Fax [ ]-260 / eMail: info@schaller.de / www.schaller.de Industrielle Automationstechnik GmbH & Co. KG KOREA SCHALLER Automation Korea (SAK) SPAIN Ocean Tower Room No. 823 BYGAP S.L. 760-3 Woo1-Dong...
Need help?
Do you have a question about the VISATRON and is the answer not in the manual?
Questions and answers