Table of Contents
Advertisement
Quick Links
PRELIMINARY OPERATIONS
TURN LEO ON
Press and old the power button for 2 seconds.
The warming up time
for gas measurement
is 15 minutes.
A full charge requires 4
hours. The recommended
first charging time is 6 hours.
QUICK INSTRUCTIONS
HAND HELD METER
SET DATE & TIME
Press on Settings
ORGANIZING DEVICES
incub 7
LEO
> System
> Date & Time
Press on Settings
> Device
.
incub 1
incub 1
REV05_DECEMBER 2022
.
Advertisement
Table of Contents
Related Manuals for Okolab LEO
Summary of Contents for Okolab LEO
- Page 1 QUICK INSTRUCTIONS HAND HELD METER PRELIMINARY OPERATIONS TURN LEO ON SET DATE & TIME Press and old the power button for 2 seconds. Press on Settings > System > Date & Time ORGANIZING DEVICES Press on Settings > Device incub 1...
- Page 2 TUBE-A to LEO gas inlet port labeled with icon TU BE -A Put the cap on LEO gas inlet port labeled with icon Connect the red labeled end of TUBE-A to the incubator or the point where measurement is required.
- Page 3 Each: the time between measurements. It is the acquisition frequency. The time can be inserted in minutes and seconds. Logging 9:11 For: is the logging function duration. Leo will perform measurements and log them in the memory For the time mbar selected here. mbar Pump Time*: the time, in minutes, the pump is active and aspirates gas, prior to saving a reading.
- Page 4 Use the fitting tubes and/or additional tube in order to allow the compatibility of the supplied tubing with the gas port of your gas cylinders. Use the OUTPUT TUBE to connect a purge tube to LEO gas outlet port. Place the purge tube in a well ventileted environment.
Need help?
Do you have a question about the LEO and is the answer not in the manual?
Questions and answers