Table of Contents
Advertisement
Available languages
Available languages
Installation
Steps 7-10
3
Place a ring of putty around drain opening of sink. Insert
threaded end of drain body up through drain hole and
attach flange to body with ball rod pointing to rear of
sink.
4
Thread lock nut from underside of sink until rubber washer
seats securely inside opening of sink. Tighten lock nut.
Wipe excess putty. If model has plastic wing nut, tighten
securely. If nut brass, tighten with wrench.
5
Place one end of spring clip on end if ball rod. Insert rod
across and through hole in lift rod strap. Secure other end.
6
Insert bottom of lift rod into hole at top of pop-up strap.
Tighten with thumb screw.
Advertisement
Table of Contents
