Installation - Pegasus LUXURY AT HAND 729071 Installation Manual

Installation

Installation - Pop-up Drain
Steps 3B-6
3B (B) Ball Nose Flexible Supplies: If you are using ball-nose
flexible supplies to connect the faucet to water supply
lines: Slip coupling nut behind ball-nose of flexible supply
tube. Ball nose coupling will go partially into IPS shank or
fitting. Tighten coupling nut (DO NOT OVER TIGHTEN).
Install opposite end according to manufacturer's
instructions for both tubes.
4 Important: After installation is completed, remove aerator.
Turn on water supply and allow both hot and cold water
to run for at least one minute each. While water is
running, check for leaks. Replace aerator. Tighten nuts
slightly to stop minor leaks. If problems persist, refer to
troubleshooting chart.
Remove flange from pop up main body. Leave large black
1
washer (not included with plastic pop ups) and nut on
drain body.
2 Unscrew the nut from the pop up body and take off the
spring clip from the ball rod (please note: retain the white
packing ring on the ball rod), and place the nut in the ball
rod. Insert the ball rod into the side hole of drain, slide
the nut on and tighten securely.