Breville Barista Touch Impress Instruction Book page 24

CLEANING THE TAMP SYSTEM
1 2
Remove Clean the chute
tamp cover with brush
4 5
Release lever Replace
tamp cover
• Remove the tamp cover.
• Brush clean the tamp face and cradle from
any dust or grinds.
• Push down and hold the lever down, using
the tamp cleaning brush, dust off grind
residues in and around the tamp.
• Slowly release the lever back up making sure
the cleaning brush is clear and out of the
tamp system area.
CLEANING THE STEAM WAND
• The steam wand should always be cleaned
after texturing milk. Wipe the steam wand
with a damp cloth.
• If any of the holes in the tip of the steam
wand become blocked, it may reduce frothing
performance.
• Go to 'Settings' > 'Steam wand cleaning' and
follow the guide on the screen.
24
CLEANING THE FILTER BASKETS
AND PORTAFILTER
3
• The filter baskets and portafilter should be
• If any of the holes in the filter basket become
Push down lever
and clean
• If the hole(s) remain blocked, dissolve
• Rinse thoroughly.
CLEANING THE SHOWER SCREEN
• The group head interior and shower screen
• Periodically purge the machine. Place an
CLEANING THE DRIP TRAY
AND STORAGE TRAY
• The drip tray should be removed, emptied
• Remove the grill from the drip tray. Lift the
• The storage tray (located behind the drip
All parts should be cleaned by hand using
warm water and a gentle dish washing liquid.
Do not use abrasive cleansers, pads or cloths
which can scratch the surface. Do not clean any
of the parts or accessories in the dishwasher.
rinsed under hot water immediately after use
to remove all residual coffee oils.
blocked, use the pin on the end of the
provided cleaning tool to unblock the hole(s).
a cleaning tablet in hot water and soak
filter basket and portafilter in solution for
approx. 20 minutes.
should be wiped with a damp cloth to remove
any ground coffee particles.
empty filter basket and portafilter into the
group head. Tap the brewing icon on the
screen and run a short flow of water to rinse
out any residual coffee.
and cleaned at regular intervals, particularly
when the drip tray is full.
coffee grind separator and dispose of any
coffee grounds. The float indicator can also
be removed from the drip tray by pulling
upwards to release the side latches. Wash all
parts in warm soapy water with
a soft cloth. Rinse and dry thoroughly.
tray) can be removed and cleaned with a soft,
damp cloth. Do not use abrasive cleansers,
pads or cloths which can scratch the surface.
NOTE