Audison DRC AC Quick Start Manual
  1. Manuals
  2. Brands
  3. Audison Manuals
  4. Remote Control
  5. DRC AC
  6. Quick start manual

Audison DRC AC Quick Start Manual

Hide thumbs
1
2
3
4
5

Advertisement

Table of Contents

20.01.23, 14:06
The DRC AC is the remote controller compatible only with the Audison line of AF bit amplifiers with
integrated Dsp. It can be connected to the DRCC port of an AF bit device by using the cable included in
the box.
It can be mounted in two ways: top mount kit or recessed mount kit.
WARNING: for both mounting cases please run the DRC AC cable through the hole as per picture above,
in order to ensure a proper LED alignment during the use of the controller.
 
The DRC AC can be used to turn on/off the amplifier and to perform a set of functions programmable on
the bit Drive software.
 

1. HOW TO USE IT

https://audison.zendesk.com/hc/en-gb/articles/9925528017809-DRC-AC
DRC AC – Audison
1/5

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DRC AC and is the answer not in the manual?

Questions and answers

Related Manuals for Audison DRC AC

Summary of Contents for Audison DRC AC

  • Page 1 LED alignment during the use of the controller.   The DRC AC can be used to turn on/off the amplifier and to perform a set of functions programmable on the bit Drive software.  ...
  • Page 2 2. the PC Power On function is not active. Long press the central part of the DRC AC to turn off the amplifier. Please, note that this can be done only if the amplifier has been previously turned on by DRC AC itself.
  • Page 3 20.01.23, 14:06 DRC AC – Audison   Click on that option to open the DRC AC settings panel:   ◼ Sleep mode: after 5 seconds without using the controller, all LEDs turn off except for one. The sleep mode is disabled as soon as the user comes back using the controller.
  • Page 4 Audison website.   In order to update the DRC AC firmware the user must do the following steps: 1. Close the bit Drive software 2. Connect the AF bit to the PC with USB 3. Connect the DRC AC to the AF bit 4. open the folder DRCCUpdate (vx.x.x.x), right-click on the file exe and select “Run as administrator”.
  • Page 5 The DRC AC will have all the LEDs active and green. 8. Press for 2 seconds the DRC AC to turn it off (in this case the amplifier will stay on) 9. Press the DRC AC to turn it back on. The device is now ready and updated.

Table of Contents