Audison VCRAK Owner's Manual

HOW TO SELECT LIGHTING COLOUR

You can choose three different colours, green, red and orange, in order to make VCRA lighting suitable to
the car dashboard it is installed on.
In order to set the colour you like, remove VCRA chassis through the two rear screws and connect the two
jumpers to the connector as indicated below. There is a short caption on the printed circuit board inside
VCRA that explains how to carry out this simple operation.
• Red (R): position 1 and 2
O
Caption
• Orange (O): position 2 and 3
• Green (G): position 1 and 3
1 2 3
DASHBOARD
MOUNTING
2
. Remove
the screws
that fasten
VCRA chassis.
Connections and
after removing the
other protective
film from the bi-
adhesive tape
insert VCRA into
the hole by pressing
R 2
1 2
R
G
O
G
Green light
Red light

PANEL MOUNTING

VCRA control module can be also
installed on panel. Please follow the
instructions below in order to install it in
the right way:
1
. Make a
rectangular hole,
32 x 40mm
(w x h).
edges and VCRA front
4
. Make
tape must be applied
with alcohol (bi-adhesive tape is given with
Warning: Make sure alcohol does not
damage the possible plastic where you drilled
the hole using it on a hidden place first.
Remove one of the two protective films from
the bi-adhesive tape and apply it on VCRA
front panel back by pressing your fingers on it,
on it.
in order to insure perfect adherence.
3
1 3
OWNER'S MANUAL
R
R
O
O
G
G
Orange light
3
. Clean the hole
panel rear surface
where bi-adhesive

TECHNICAL FEATURES

Power supply:
the device).
Bandwidth:
Gain:
Fuse:
VCRA lighting:
Muting:
VCRAK
SUBWOOFER
10 ÷ 15VDC
10 Hz ÷ 50 kHz
-100 ÷ +6 dB
250 mA, delayed (T)
green, red, orange
internal
- 62018 Potenza Picena (MC) - Italy - Tel. +39 0733 870.870 - Fax +39 0733 870.880 www.audison.com
Subwoofer volume remote control kit