NEC N8190-173 User Manual page 48

4.
Mate the cable connector and the connector of this product firmly in the correct direction.
Push the latch of the Fibre Channel cable to avoid conflict with the computer

flame and then insert the Fibre Channel cable until you hear it click.
Notice
If it is difficult to push the latch of the Fibre Channel cable when connect or remove

the Fibre Channel cable, use a flathead screwdriver to push the latch.
Tips
5.
Mate the other end of the cable connector and the Fibre Channel device firmly in the correct
direction.
 Use Fibre Channel cables under conditions that conform to the cable
specification (length between device, Fibre Channel data rate and so on).
Notice
 Please contact the retailer or service center for the information on recommended
computers or Fibre Channel cables.
 Please refer to the user's guide of the product for information on how to setting
Check
Fibre Channel device.
6.
Plug the power cord of the Fibre Channel device into the electrical outlet. For detailed
information, please refer to the user's guide of the Fibre Channel device.
7.
Plug the power cord of the computer into the electrical outlet.
- 46 -