Fisher & Paykel DISHDRAWER 9 Series Installation Manual page 10

Hose and cord lengths
Your services can be installed to either the left-hand or right-hand side
z
of the product in an adjacent cabinet. Refer to 'Cabinetry preparation'
for service access requirements.
If the drain hoses supplied are not long enough to reach your services,
z
you may purchase a Fisher & Paykel drain hose extension kit which will
extend the drain hoses by 12' (3.6m) (part number 525798).
Water connection
Recommended water temperature: Hot (Maximum 140°F/60°C).
z
Supplied hose to suit 3/8" (9 mm) male compression fitting.
z
Ensure water connection complies with local plumbing regulations.
z
Water pressure
Water softener models: max. 1 MPa (145 psi), min. 0.1 MPa (14.5 psi)
z
Non-water softener models: max. 1 MPa (145 psi), min. 0.03 MPa (4.3 psi)
z
Electrical requirements
120V, 60 Hz, 15A
z
Kosher requirements
Drains will need to be separated to satisfy kosher requirements.
z
We recommend confirming the acceptability with your local rabbi in
z
respect to kosher installations.
10
PLUMBING & ELECTRICAL CONSIDERATIONS
d
e
f
SERVICE DIMENSION
A Length of drain hoses
B Length of power cord**
C Length of inlet hose
D Minimum distance from floor to top of
hose support
E Minimum distance from floor to end of
drain hoses***
F Minimum distance from floor to inlet
hose connection
G Maximum distance from cabinetry
centre of electrical outlet
H Maximum distance from floor to top of
Air Break
*dimensions taken from the chassis edge where applicable
**excluding plug
***standpipe install illustrated. Distance is the same for sink trap installations.
g
c b a
INCHES
78 1/2
64 15/16
64 15/16
29 1/2 –
4 3/4
19 11/16
7 7/8
17 11/16
37 3/8
g
e
f
a b c
LEFT SIDE* RIGHT SIDE*
MM INCHES
2000 70 7/8
1650 64 15/16
1650 49
29 1/2 –
750 – 883 750 – 883
4 3/4
500 19 11/16
200 7 7/8
450 17 11/16
950 37 3/8
d
MM
1800
1650
1250
500
200
450
950