Operation - Dimplex DHCH20E Instruction Manual

Operation

Note: Before inserting the plug into an electrical outlet, make sure that the elec-
trical supply in your area matches that on the rating label of the unit.
1. When the unit is plugged in, turn the POWER SWITCH on at the back of the
unit to enter standby mode.
2. When in standby mode, press the POWER button once on the control panel
to make the LED display show the room temperature. Press the POWER but-
ton again to access the rest of the functions.
3. To enter low heat mode, press the HEAT button once. The heater will work at
1200W, and the heat symbol (
mode, press the HEAT button again. The heater will work at 2000W, and two
heat symbols will show on the display (
4. To use the timer, press the TIMER button. Each time you press this button, the
timer will increase by 1 hour, from 1-8 hours.
5. To adjust the room temperature, use the TEMP UP and TEMP DOWN buttons.
These will increase or decrease the temperature by 1°C. The unit ranges from
10-35°C. If the room temperature is up to 4°C lower than the set temperature
of the unit, the unit will work on high heat mode. If the room temperature is
only 2°C lower or less, the unit will work on low heat mode. When the room
temperature reaches the set temperature, the heating function will stop and
the fan will run until the room temperature is lower again, and the unit will
take action as above.
6. Press the OSCILLATION button to allow the unit to swing left to right. Press
this button again to stop.
Note: Press the On/Off button to turn off the unit. The heating will stop immedi-
ately and the fan will operate for approximately 30 seconds before switching off
completely, allowing the unit to cool down.
Display Lights
After 10 minutes of operation, if no further function has been activated, the unit
will enter sleep mode and all display lights will switch off. To exit sleep mode,
click any button.
) will show on the display. To enter high heat
) ( )
9