Advertisement
Cut tie wire (G) into four pieces of equal length. Insert wires through ends of turnbuckles. Twist each wire around itself
at least four times.
Drill holes for four ceiling anchors (see "Various Anchoring Methods"). Position the holes so that when the tie wires
(G) are attached and taut will angle out at 15
Pull tie wires tight and attach to ends of ceiling anchors (or truss). Again twist each wire around itself at least four
times.
When this step is complete, the weight of the ceiling tray should be supported by the tie wires.
Note: 20' (6.1 m) of tie wire (G) is provided. If space between the true ceiling and suspended ceiling is more than 36"
(914 mm), additional wire (12 gauge annealed, steel, black) will be needed.
Wood Joists or Beams
Drill 5/32" (4mm) dia.
holes 2" (51mm) deep.
Fully insert eye bolts (H).
H
WARNING
• It is the responsibility of the installer to verify that the
ceiling to which the suspended ceiling kit is anchored
will safely support the combined load of all attached
components (Projector Mount, Extension Column,
etc.) and equipment.
• Never attach hooks to filler tray.
Suspended Ceiling Kit installation is now complete.
After all components (Projector Mount, Extension
Column, etc.) and equipment have been attached,
tension the tie wires by adjusting turnbuckles (F).
Load must be carried by tie wires - not suspended
ceiling runners.
Visit the Peerless Web Site at www.peerlessindustries.com
© 2004 Peerless Industries, Inc. All rights reserved.
Peerless is a registered trademark of Peerless Industries, Inc.
All other brand and product names are trademarks or registered trademarks of their respective owners.
O
.
VARIOUS ANCHORING METHODS
Solid Concrete
Drill 1/4" (6 mm) dia. holes 1.5" (38 mm) deep.
Hammer in Concrete Anchor (I) using Rawl
#3250 setting tool or equivalent.
I
3 of 3
Truss Ceiling
No anchor required. After
attaching tie wire to turnbuckle
loop upper end around ceiling
truss. Pull tie wire tight and
twist it around itself at least
four times.
G
G
2'
1.5"
DETAIL 2
Ceiling Runner
For customer service call 1-800-729-0307 or 708-865-8870.
15°
G
G
A
Holes are provided for
electrical outlet boxes
and antenna leads.
ISSUED: 12-16-04 SHEET #: 120-9015-1
Advertisement
