Advertisement
Quick Links
Before you start...
Please read entire instruction sheet and check the parts list to insure that all parts and fasteners
have been included.
Recommended tools:
QTY.
DESCRIPTION
A
1
ceiling tray
B
4
1/4"-20 x 3/8" screws (not shown)
C
4
1/4"-20 nuts (not shown)
D
1
allen wrench
F
4
turnbuckle
G
1
20' (6.1m) tie wire (not shown)
H
5
eye bolt
I
5
concrete anchor
J
1
flush mount tube
K
1
M5 x 10 mm penta pin screw
L
1
M5 x 1" penta pin driver
M
1
escutcheon ring
Note: You may not need all hardware provided.
F
Visit the Peerless Web Site at www.peerlessindustries.com
Installation and Assembly: Lightweight Adjustable
Phillips screwdriver, hammer and wire cutters, drill and drill bits.
PART #
055-0492
520-2015
530-9302
560-9706
560-9620
600-2008
580-0006
580-0005
1446-014
505-9010
520-9249
1418-001A
H
Lightweight Adjustable Suspended Ceiling Plate for Projector
Model
Number
SCP 100
• Weight of projector and mount not to exceed maximum load
capacity.
Suspended Ceiling Plate
for Projector Mounts
This Adjustable Suspended Ceiling Plate is intended for use only to
support Projector Mounts or other products as specified by Peerless.
I
D
Mounts - Specifications
Max. Load Capacity
Concrete
60 lb
(27 kg)
WARNING
1 of 3
For customer service call 1-800-729-0307 or 708-865-8870.
K
J
Wood
60 lb
(27 kg)
ISSUED: 12-16-04 SHEET #: 120-9015-1
Model:
SCP 100
A
L
M
Advertisement
Related Manuals for NEC SCP100
Summary of Contents for NEC SCP100
- Page 1 Installation and Assembly: Lightweight Adjustable Before you start... Please read entire instruction sheet and check the parts list to insure that all parts and fasteners have been included. Recommended tools: Phillips screwdriver, hammer and wire cutters, drill and drill bits. QTY.
- Page 2 IMPORTANT PRE-ASSEMBLY INFORMATION: Ceiling Tray (A) is designed to fit above a 24" (610 mm) x 24" (610 mm) section of a conventional suspended ceiling system. It may also be mounted above 24" x 48" conventional suspended ceiling. Ceiling runners (see DETAIL 2, page 3) should have a “T”...
- Page 3 Cut tie wire (G) into four pieces of equal length. Insert wires through ends of turnbuckles. Twist each wire around itself at least four times. Drill holes for four ceiling anchors (see "Various Anchoring Methods"). Position the holes so that when the tie wires (G) are attached and taut will angle out at 15 Pull tie wires tight and attach to ends of ceiling anchors (or truss).