Speaker Cords; Cord Clampers - NEC PX-SP4U/B Instruction Manual

5
Tighten the loosely inserted screws in 4 locations fully into place.
∗
Push the speakers lightly onto the plasma monitor when tightening the screws.
Check to make sure that the screws at all 4 locations have been firmly screwed into place.
Warning
Connecting speaker cords
Be sure to turn off the power to the plasma monitor before
connecting the speakers.
Use the provided speaker cords to connect the R/L speaker jacks of
the plasma monitor to the speaker jacks of the speakers.
Once the cords have been connected, pull on the cords
lightly to make sure that they have been connected
firmly to the speaker jacks. An improper
connection might result in the sound
being interrupted or the appearance
of noise in the output sound.
¶
Never hold the speakers when speakers are attached to the plasma monitor to move the
plasma monitor. Doing so might result in the plasma monitor falling, and this in turn might
result in bodily injury.
¶
Be sure to screw the screws firmly into place. Failing to do so might result in the speakers
falling, and this in turn might result in bodily injury.

Cord clampers

Remove the protective tape from the rear of the cord clampers, attach
the clampers in the desired position, and clamp the cords into place.
When attached to a 50-inch
plasma monitor
R
R
Note that the speaker cords have positive
and negative ends, and that you should be
sure to insert them correctly.
Press the button of the speaker jack and
keep it pressed down as you insert the wire
of the speaker cord and then release the
button.
5
L
L
Black
Red