AMIMON does not warrant or represent that any license, either express or implied, is granted under any AMIMON patent right, copyright, mask work right, or other AMIMON intellectual property right relating to any combination, machine, or process in which AMIMON products or services are used.
Introduction The AMNPTTX01 and AMN42012 are wireless video system comprising of a video transmitter and video receiver modules, that operate at the 5 – 6.425GHz unlicensed band. They are based on AMIMON's Professional chipset that consist of the AMN2130 and AMN2230 baseband receiver and the MAXIM 2850 and 2851 ICs, providing the ultimate solution for 4K Video transmission.
Page 11
Indication output (Power, Network, Video Indications) Board attached ID pins UART Host manufacturers are advised to contact Amimon to request the complete pin allocation and functional description of the interface board. Amimon Ltd. 26 Zarhin St. Raanana, Israel. Tel: +972-9-9629222 www.amimon.com...
See ‘Product Description’ for port location described in this section. Connect AMIMON modules to the compatible Video Interface Board (VIB). Connect the antennas to the modules. Only use antennas provided by AMIMON Connect the receiver VIB to a video monitor through the supported video interface of the VIB.
Requirements The AMNPTTX01 and AMN42012 modules can’t be bought off-the-shelf. This section is intended to guide host manufacturer integrating the AMNPTTX01 and AMN42012 modules inside their end products with the regulatory requirements. Host integrators must comply with the following requirements when operating in the...
Page 15
The OEM must design the host so that the antenna will be installed as an integrated antenna for the host containing the AMNPTTX01 and the end user shall not be able to access, remove or replace the antenna. Manual Requirements: Manual to the end user must contain the following...
Page 16
(e.i.r.p.) is not more than that necessary for successful communication Les présent émetteur radios 7680A-AMNPTTX01, et 7680A-AMN42012 ont été approuvé par Industrie Canada pour fonctionner avec les types d'antenne énumérés ci-dessous et ayant un gain admissible maximal et l'impédance requise pour chaque type d'antenne.
Page 18
In the 5.925-6.425 GHz band, devices containing AMN42012 (which is a client device) must operate under the control of a device containing the AMNPTTX01 which is an indoor access point. In all cases, an exception exists for transmitting brief messages to an access point when attempting to join its network after detecting a signal that confirms that an access point is operating on a particular channel.
Page 19
AMNPTTX01 and AMN42012 do not have a battery backup. If host devices containing AMNPTTX01 module are designed to have a battery backup, the use of the backup battery should only be allowed during power outages and for indoor use.
Need help?
Do you have a question about the AMNPTTX01 and is the answer not in the manual?
Questions and answers