Table of Contents
Advertisement
Connect to the Network
You can connect to the router network through a wired or WiFi connection. If you set up your computer to use a
static IP address, change the settings so that it uses Dynamic Host Configuration Protocol (DHCP).
Wired Connection
You can connect your computer to the router using an Ethernet cable and join the router's local area network (LAN).
To connect your computer to the router with an Ethernet cable:
1.
Make sure that the router is receiving power (its Power LED is lit).
2.
Connect an Ethernet cable to an Ethernet port on your computer.
3.
Connect the other end of the Ethernet cable to one of the numbered Ethernet ports.
Your computer connects to the local area network (LAN). A message might display on your computer screen
to notify you that an Ethernet cable is connected.
WiFi Connection Using WPS
You can connect to the router's WiFi network with Wi-Fi Protected Setup (WPS) or you can find and select the WiFi
network.
To use WPS to connect to the WiFi network:
1.
Make sure that the router is receiving power (its Power LED is lit).
2.
Check the WPS instructions for your computer or WiFi device.
3.
Press the WPS button on the router.
4.
Within two minutes, on your computer or WiFi device, press its WPS button or follow its instructions for WPS
connections.
Your computer or WiFi device connects to the WiFi network.
WiFi Connection
To find and select the WiFi network:
1.
Make sure that the router is receiving power (its Power LED is lit).
2.
On your computer or WiFi device, find and select the WiFi network.
The WiFi network name is on the label on the router.
3.
Join the WiFi network and enter the WiFi password.
The password is on the label on the router.
Nighthawk X4S AC2600 Smart WiFi Router
Connect to the Network and Access the Router
18
Advertisement
Table of Contents
