Advertisement
It is the responsibility of the users to assure they are familiar with the instructions, and are trained in
the correct care and use of this equipment. Users must also be aware of the operating characteristics,
application limits, and the consequences of improper use of this equipment.
Frequency:
Before each use, inspect the Fixed Beam Anchor according to following steps and see FIXED BEAM
ANCHOR COMPONENTS for part identification. The Fixed Beam Anchor must be formally inspected by a
competent person other than the user at least annually. Record the results in the inspection and
maintenance log in INSPECTION AND MAINTENANCE LOG
Inspection Steps:
Step 1.Inspect Fixed Beam Anchor for damage: Look for cracks, dents, or deformities. Look for
bending or wear on the hexagonal rod, beam clamps, quick release lock pin, and tightening
handle. Ensure no parts are missing.
Step 2. Inspect entire unit for excessive corrosion.
Step 3. Ensure the quick release lock pin can be inserted through the hole on safety lock button, and
locks in place.
Step 4. Record the inspection date and results in the inspection and maintenance log.
If inspection reveals an unsafe or defective condition remove unit from service and destroy, or return to
Tiger for repair.
NOTE: Only Tiger or parties authorised in writing are qualified to repair this equipment.
Cleaning:
Periodically clean the Fixed Beam Anchor by water and a mild soap solution. Do not use acids or other
caustic chemicals that could damage the system components. A lubricant may be applied to the quick
safety lock button and release lock pin.
Storage:
Store the equipment in a cool, dry, dark place, chemically neutral, away from sharp corners, sources of
heat, humidity, corrosive substances or other damaging conditions.
TRAINING
INSPECTION
MAINTENANCE, SERVICE, STORAGE
Advertisement
