Advertisement
Installation configuration:
Bottom Mount
Inspect the equipment according to INSPECTION of this manual before each use.
The Fixed Beam Anchor could be installed on any I-beam for both Horizontal and Vertical use. The Fixed
Beam Anchor could be located on the top, bottom (horizontal) or side (vertical) of I-beam.
Step 1. Remove the quick release lock pin. Open the adjustable beam block by turning the tightening
handle counter-clockwise. Then press the safety lock to adjust the beam size.
Step 2. Place the Fixed Beam Anchor onto beam flange in your required position (top, bottom, side).
Step 3. Place fixed beam clamp against one side of the beam flange. Slide the adjustable clamp against
opposite side of the beam flange.
Step 4. Ensure the safety lock is in nearest position to the beam flange.
Step 5. Insert the quick release lock pin to fix the safety lock, ensuring pin is locked into place.
Step 6. To secure the Fixed Beam Anchor onto the flange, swivel the tightening handle away from the
hexagonal rod and turn adjustment handle clockwise in half turns. Ensure beam clamps are tight
against both sides of the flange. Only hands tighten is allowed. Ensure the quick release lock pin has
not bottomed out. If adjustment pin has bottomed out, reinstall the Fixed Beam Anchor to the next
locking position. If the quick release lock pin is damaged or absent, the equipment is still in
workable condition. However, for safety concerning, when the quick release lock pin is damaged or
absent, the equipment must be sent back to your dealers, distributors, or manufacturer to replace a
new quick release lock pin.
INSTALLATION AND USE
Top Mount
Side Mount
Advertisement
