Table of Contents
Advertisement
RESET TO FACTORY DEFAULTS
Press and hold the button on the BTC-ASV for 15 seconds. This will remove all app settings, historical information,
and any set passwords. This is the only way to remove a password so try not to forget it!
TECHNICAL ASSISTANCE
Should you encounter any problem(s) with this product or if you do not understand its many features, please refer
to this operating manual first. If further assistance is required, DIG offers the following customer support:
• DIGPRO Technical Service USA: DIG's Technical Service Team is available to answer questions in English and
Spanish from 8:00 AM to 5:00 PM (PST) Monday-Friday (except holidays) at 1.800.344.2281 or 1.760.727-0914.
• Questions also can be e-mailed to questions@digcorp.com or faxed to 760.727.0282.
• Specification documents and manuals are available for download at www.digcorp.com.
• Customer Assistance Outside the USA: Contact your local distributor
FCC
This device complies with FCC and IC radiation exposure limits set forth for an uncontrolled environment. The
device should be installed and operated with a minimum distance of 20cm between the radiator and your body.
This device must not be collocated or operating in conjunction with any other antenna or transmitter.
I. Changes or modifications not expressly approved by DIG Corporation could void the user's authority to operate
the equipment.
II. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one of the following measures: Reorient or relocate
the receiving antenna. Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.Consult
the dealer or an experienced radio/TV technician for help.
III. Industry Canada
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following
two conditions: (1) this device may not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage,
et (2) l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
14
Advertisement
Table of Contents
