Do you have a question about the BO92A and is the answer not in the manual?
Questions and answers
Chuck
April 17, 2025
Installed new battery twice, still dead. No led and no sound from valve opening. No sign of water leak.
1 comments:
Mr. Anderson
May 9, 2025
If the DIG BO92A valve does not show any LED light or sound after installing a new battery, the issue could be one of the following:
1. The battery is not connected properly. 2. The battery is not a 9V alkaline type as required. 3. The battery compartment is wet, causing a malfunction. 4. The battery is dead or defective. 5. The unit is damaged or defective.
Ensure the battery is correctly connected, dry, and in good condition. Use only a 9V alkaline battery.
SET AuTOMATIC wATERINg SET RUN TIME & WATERING INTERVAL 1..Turn.“LEFT”.dial.to.select.RUN.TIME. 2..Turn.“RIGHT”.dial.to.select.INTERVAL. 3..Push.“ENTER”.–.The.Red.LED.will.appear.solid. for.10 seconds.to.confirm.your.selections,. and.then.run. Watering will start in 24 hrs at the selected INTERVAL.
CHANgINg START TIME TO CHANGE THE START TIME (Minimum 6 Hours) 1..While.the.Red.LED.is.solid.ON,.turn.the. “RIGHT”.dial.to.select.the.DELAY.time.&.press. “ENTER”.again..This.moves.the.START.time. forward.by.the.hours.selected. RUN TIME will begin then & thereafter at selected INTERVAL.
MANuAL START SETTING THE TIMER TO START MANUALLY 1..Turn.“LEFT”.dial.to.select.RUN.TIME. 2..Turn.“RIGHT”.dial.to.MAN.and.press.“ENTER”. Note:.Running.a.manual.run.time.will.not.change. any.program.previously.entered. Watering will begin and end at selected RUN TIME.
STOp OR NO wATERINg HOW TO STOP THE TIMER WATERING 1..Turn.“LEFT”.dial.to.the.OFF.position. While the RUN TIME (Left) dial is in the “OFF” position NO watering will happen. Note:.To.re-commence.automatic.operation,. move.the.“RUN TIME”.dial.to.any.other.position.
RED LED – OpERATINg STATES Red LED – OPERATING STATES as follows: 1..SOLID: Confirms.program.&.allows “START TIME” change. 2. FLASHING – 20 Seconds: “ALL IS RUNNING CORRECTLY”. 3. FLASHING – 1 Second: “BATTERIES NEED CHANGING”.
Need help?
Do you have a question about the BO92A and is the answer not in the manual?
Questions and answers
Installed new battery twice, still dead. No led and no sound from valve opening. No sign of water leak.
If the DIG BO92A valve does not show any LED light or sound after installing a new battery, the issue could be one of the following:
1. The battery is not connected properly.
2. The battery is not a 9V alkaline type as required.
3. The battery compartment is wet, causing a malfunction.
4. The battery is dead or defective.
5. The unit is damaged or defective.
Ensure the battery is correctly connected, dry, and in good condition. Use only a 9V alkaline battery.
This answer is automatically generated