Additional Descriptio - Sharp SD-AT50 Service Manual

(J1)x4
ø4x16mm
Subwoofer
Box
Figure 7-1
Disassembling the Lot 1 (when using the old parts)
Remove the 5 screws on the backside of the top cabinet. Raise the rear end by approx. 10 mm, and then move it backward by
approx. 8 mm. Keep the top cabinet horizontal and raise it right above to remove.
Remove the 4 cushions and the 4 screws and slide it right backward.
Disassembling the Lot 2 (when using the new parts)
Remove the 5 screws on the backside of the top cabinet. Raise the rear end by approx. 10 mm, remove the hooks of the front panel,
and then move it backward by approx. 8 mm. Keep the top cabinet horizontal and raise it right above to remove.
Remove the 4 cushions and the 4 screws. Push down around the center of the bottom cabinet with a steel measure or like to remove
the tab. Slide the bottom cabinet right backward to remove.
Insert a steel measure and push down the bottom
cabinet to detach the hook.
The top cabinet is removed
Subwoofer
ADDITIONAL DESCRIPTION
– 7 –
(Note 1)
Wrap a slotted screwdriver with a waste cloth, etc. and insert
it into the gap to remove the front panel. Take great care not
to damage the subwoofer box.
Screwdriver
Front
Panel
Figure 7-2
SD-AT50
Subwoofer
Box