VDO AS47-G CS Installation Manual page 39

General information about the
structure:
The assembly locations of the system components and the dimensions of the vehicle hall must be entered in the
attached planning sketch and submitted to the responsible authorities (Federal Network Agency in Germany)
with the application from.
In the sketch, please enter the distances of the receiver and the repeater from the floor to the hall gate.
To prevent interference risks due to feedback, the choice of installation location must be considered:
• Direct distance (as the crow flies, point to point!) between repeater and receiver must be at least 10m
• Repeaters and receivers should not be in direct sight of each other and need to be separated by one or more
building envelopes! (walls/roofs)
• Receiver should not be installed directly in front of or above doors, gates, windows or skylights, ventilation
hoods or other openings!
To prevent the risk of interference from outside the building, the following points must be considered for the
choice of the installation location and the operation of the repeater:
• Repeater is only installed and operated inside buildings!
• Repeater is mounted in the center of the building, in the middle of the hall!
• Repeater is not mounted directly on external walls, in front of facades and hall gates and is separated from the
outside by at least one building envelope
• Repeater is only used for vehicle testing and closed hall gates!
Otherwise the repeater will be switched off!
GNSS Repeater Buch 1.indb 107
General information about the structure:
107
18.01.2019 16:06:17