Mounting - NEC MultiSync LCD1770GX User Manual

Mounting

Remove Monitor Stand for Mounting
To prepare the monitor for an alternate mounting method:
1. Place hands on each side of the monitor and lift up to the highest position.
Remove the cable cover (Figure M.1).
NOTE: If you have difficulty removing the cable cover, please
push the the notch at the bottom of the cover up
(towards the top of the monitor)in order to unhook the
cover from the stand, as shown in the following
figure.
2. Disconnect all cables.
3. Place monitor face down on a non-abrasive surface (Figure M.2).
NOTE: Handle with care when the monitor is facing down to avoid damaging
the front buttons.
4. Remove the 2 screws connecting the stand to the monitor (Figure M.2).
5. Lift up the stand to unlatch the upper hooks and remove the stand (Figure M.3).
6. Remove the 2 screws on the top of the monitor (Figure M.4). The monitor is
now ready for mounting in an alternate manner.
7. Connect the cables to the back of the monitor.
8. Reverse this process to reattach stand.
NOTE: Use only VESA-compatible alternative mounting method.
Handle with care when removing stand.
Figure M.1
Figure M.3
LCD1770GXManual011305.pmd
Figure M.2
7
7
Figure
Figure M.4
1/14/05, 5:04 PM