icherng WA Series User Manual page 11

How to connect wire to WAGO
1. Strip wire to suitable length (6~10mm).
2. Use the flat screw driver insert into the clamp
releasing hole. While screw driver inserted the
clamp inside is opened.
WAGO Terminal module
WAGO 端子模組
3. Insert the electric wire into the connection hole.
WAGO Terminal module
WAGO 端子模組
4. Remove screw driver, the wire is clamped. Check
the wire if clamped firmly.
WAGO Terminal module
WAGO 端子模組
*WAGO is a trade mark of WAGO company.
terminal modules 如何連接電線到 WAGO
*
6~10mm
Screw driver
螺絲起子
1.將電線剝線約 6~10mm。
2.利用扁平的螺絲起子插入電線夾持釋放孔，使內部
彈簧夾開啟。
Screw driver
螺絲起子
3.將電源線插入連接孔。
Electric wire
電線
4.移離螺絲起子，電線即被夾緊。檢查電線是否被夾
緊。
Electric wire
電線
*WAGO 為德國 WAGO 公司的商標。
7
*
端子模組