Table of Contents
Advertisement
3.2 Positioning condenser
In order to get the best performance of your
condenser, you must install the condenser in a correct
place.
The following general rules must be followed
while selecting the position for condenser:
1. This series condenser must be installed indoors and
there must be no obstacle on both inlet and outlet air
side. This condenser is NOT designed for installing
air duct and NOT for outdoor application.
2. In order to get better air flow, please do consider air
tunnel in your system.
cabinet. .
3. When install multi-condensers system, do avoid the
air flow interference between condensers.
avoid one's discharged flow becomes another one's
inlet air. Air inlet side must be kept at least 150mm
away from wall.
4. Please avoid the corrosive environment, if it has to be,
order anti-corrosion type and clean the condenser
more often.
Before installation, check the position and reserve
maintenance space.
Caution！ 注意！
Sharp edge hazard!
小心銳利邊緣危害！
L
1
＞＝150mm
L
1
＞＝150mm
L
1
Especially installed in a
Must
Must avoid one's discharged flow becomes another one's inlet air.
避免一個冷凝器的排風成為另一個冷凝器的入風。
3.2 冷凝器的安裝位置
為了確保冷凝器能發揮最大的效能，必須要將冷
凝器裝置在正確的位置。在選擇安裝位置時，必須要
遵守以下的通則：
1. 本系列冷凝器必須要安裝於室內，且進排風側必
須要無障礙物。本系列冷凝器並非為安裝風管所
設計且非設計於室外安裝。
2. 為獲得較佳的氣流，請考慮安裝於系統中之氣流
通道，特別是安裝於箱體中的情形時。
3. 在使用多組冷凝器系統時，要注意避免冷凝器之
間的氣流互相干擾，避免一個冷凝器的排風成為
另一個冷凝器的入風，如果必須要入風側對入風
側的安裝，兩個冷凝器間的距離至少要為一個葉
徑的距離 。 入風側與牆的距離至少要為 150mm 的
距離。
4. 請儘可能避開安裝於腐蝕性的環境，如果必須如
此，請選購防蝕型機種並經常清洗冷凝器。
在安裝前務必確認位置，並預留維護空間。
＞＝One fan blade diameter
L
1
＞＝一個葉徑的距離
L
1
3
L
1
Advertisement
Table of Contents
