Indoor Unit Fixing; Drainage; Outdoor Unit; Installation Place - Toshiba RAS-10SAV Series Installation Manual

Indoor Unit Fixing

1. Pass the pipe through the hole in the wall and hook the indoor
unit on the installation plate at the upper hook.
2. Swing the indoor unit to right and left to confirm that it is firmly
hooked up on the installation plate.
3. While pressing the indoor unit onto the wall, hook it at the lower
part on the installation plate. Pull the indoor unit toward you to
confirm that it is firmly hooked up on the installation plate.
Hook here.
1
1
Installation plate
2
Hook
• For detaching the indoor unit from the installation plate, pull the
indoor unit toward you while pushing its bottom up at the
specified parts.
Push

Installation Place

• A place which provides the spaces around the outdoor unit as
shown in the diagram
• A place which can bear the weight of the outdoor unit and does
not allow an increase in noise level and vibration
• A place where the operation noise and discharged air do not
disturb your neighbors
• A place which is not exposed to a strong wind
• A place free of a leakage of combustible gases
• A place which does not block a passage
• When the outdoor unit is to be installed in an elevated position,
be sure to secure its feet.
• An allowable length of the connecting pipe is up to 10 m.
• An allowable height level is up to 8 m.
• A place where the drain water does not raise any problems
Toshiba 1108651069 (01_EN)
Press
(unhook)
Push

OUTDOOR UNIT

6

Drainage

1. Run the drain hose sloped downwards.
NOTE
• The hole should be made at a slight downward slant on the
outdoor side.
Do not rise the
drain hose.
50 mm
or more
Do not put the
drain hose end
into water.
2. Put water in the drain pan and make sure that the water is
drained out of doors.
3. When connecting extension drain hose, insulate the connecting
part of extension drain hose with shield pipe.
Shield pipe
Drain hose Inside the room
CAUTION
Arrange the drain pipe for proper drainage from the unit.
Improper drainage can result in dew-dropping.
This air conditioner has the
structure designed to drain
water collected from dew, which
forms on the back of the indoor
unit, to the drain pan. Therefore,
do not store the power cord and
other parts at a height above
the drain guide.
CAUTION
1. Install the outdoor unit without anything blocking the air
discharging.
2. When the outdoor unit is installed in a place always exposed
to strong wind like a coast or on a high storey of a building,
secure the normal fan operation using a duct or a windshield.
3. In particularly windy areas, install the unit such as to avoid
admission of wind.
4. Installation in the following places may result in trouble.
Do not install the unit in such places.
• A place full of machine oil
• A saline-place such as the coast
• A place full of sulfide gas
• A place where high-frequency waves are likely to be
generated as from audio equipment, welders, and medical
equipment
6
2/20/07, 9:54 AM
Do not form the
drain hose into
a wavy shape.
Do not put the
drain hose end
in the drainage
ditch.
Extension drain hose
Wall
Drain
guide
Space for pipes
Strong
wind
Toshiba 1108651069 (EN)