NAD T737 Owner's Manual page 10

IDENTIFICATION OF CONTROLS
REAR PANEL
15 DAB MODULE INPUT (230V version only): Plug-in the other end
of the Mini-Din connector from the NAD DAB Adaptor DB 1 module
output port into this socket. The T 737 is compatible only with NAD
DAB Adaptor DB 1 so check with your NAD dealer for this module's
availability. With DAB, you can receive CD-like quality programs without
any annoying interference and signal distortion.
NOTE
The external "NAD DAB Adaptor DB 1 module" is not supplied with your
T 737.
16 RS-232: Connect this interface via RS-232 serial cable (not supplied)
to any Windows® compatible PC to allow remote control of the T 737
through NAD's proprietary PC software or other compatible external
controllers. NAD is a certified partner of AMX and Crestron and fully
supports these external devices. See your NAD audio specialist for more
information.
17 AUDIO 5 IN/OUT, AUDIO 6: Input for additional line level input signals
such as CD player, MP player or a tape recorder. Connect AUDIO 5 OUT
to the analog audio input of a recording component such as a cassette
deck, CD recorder or to an outboard audio/video processor. Connect
the AUDIO 5 IN jacks to the component's corresponding output.
AUDIO 6 is ideal for the connection of the analog output of line-level
audio sources like a CD player or Stereo tuner.
18 SPEAKERS: Connect the respective speaker's FRONT L, FRONT R,
CENTER, SURROUND R, SURROUND L, SURROUND BACK L, SURROUND
BACK R and CENTER channels to their corresponding loudspeakers.
Make sure the "+" (red) terminal and "-" (black) terminal are connected
to the corresponding "+" and "-" terminals of the loudspeaker. Use extra
care to ensure that no stray wires or strands cross between posts or
terminals at either end.
The T 737 is designed to produce optimum sound quality when connected
to speakers with impedances within its operating range. Please make sure
that all the speakers are rated 8 ohms minimum per speaker.
NOTE
Use stranded wire of at least 16 gauge (AWG). Connections to the T 737
can be made with banana plugs (120 V version model only) or by using
bare wire or pins.
19 SWITCHED AC OUTLET: This convenience outlet can supply switched
power to another component or accessory. It is powered ON and OFF
by the front panel POWER button or by the AVR 3's ON and OFF keys.
The total draw of all devices connected to this outlet must not exceed
50 watts.
20 AC MAINS INPUT: The T 737 comes supplied with a separate AC Mains
cable. Before connecting the cable to a live wall socket, ensure that it
is firmly connected to the T 737's AC Mains input socket first. Connect
only to the prescribed AC outlet, i.e., 120V 60 Hz (for 120V version
models of T 737 only) or 230V 50 Hz (for 230V version models of T 737
only). Always disconnect the AC Mains cable plug from the live wall
socket first, before disconnecting the cable from the T 737's Mains input
socket.
10