Mustek MDC-800 User Manual page 42

42
No Image is present
Cannot open the
Photo Album
Cannot transfer data
CF Card error
Cannot delete image
"Device not ready"
Connection Failure
Cannot connect at startup
or cannot transfer
image/thumbnail
Symptom
1. Operation Mode Selector is set to
camera mode
2. If using a TV, wrong channel is selected
3. Not connected properly
4. Wrong TV system
1. Software is not installed
2. Not using Windows 98 with USB
connection
1. Incorrect cable connection
2. Camera is not turned on
1. CF Card is not formatted
1. Operation Mode Selector is in Camera
mode
2. The image is protected
3. There are no images to delete
1. Camera is not powered on
2. USB not connected properly
OR
3. USB host controller problem
4. USB data transfer error
5. Hardware compatibility problem
1. RS232 port not functioning properly
2. Current Baud rate not supported
Cause
1. Set selector to Playback mode
2. Set TV to correct channel for video
3. Reconnect the cables
4. Use NTSC or PAL TV system only.
1. Install the software (see chapter 4)
2-1. Use Windows 98 as your Operating
2-2. Use RS-232 connection (see chapter 3)
1. Reconnect the cables
2. Turn on the camera
1. Reformat through DOS using CF Adapter
1. Select Playback mode/Delete Menu
2. From Playback mode, unprotect the image
3. Have fun. Take pictures.
1. Power on the camera
2. Ensure USB cable is properly connected
3. Refer to the Control Panel/Systems/Device
4. Unplug and reconnect the USB cable
5. Contact your computer vendor for help
1. Use another RS232 port and check to see
2. Select a slower baud rate (from Settings)
Solution
playback
system
and PCMCIA slot.
Manager for more details
if it works by connecting a mouse first.
and try again.
C
ONTENTS