Kohler K-3588 Installation Manual page 7

Styrofoam
Block
Waste
Tube
Gasket
3. Install the Toilet
CAUTION: Risk of back injury. Because the toilet is heavy
and awkward, two people should move the toilet into place.
Reinstall the gasket to the waste tube.
Tilt the toilet to one side and install the waste tube.
Position a support block under each side of the toilet to raise the
base 3" (7.6 cm) off the floor. The blocks should be positioned so
the supply hose can reach the supply when the toilet rests on
them.
Wet the gasket thoroughly with soapy water or O-ring lubricant.
Insert the provided foam block into the gap between the waste
tube and the surface above it. This will provide support to keep
the waste tube from shifting while inserting the waste tube into
the waste outlet.
Connect the supply hose to the supply stop and bring it up
through the opening in the bowl, to be connected with the fill
valve, when installing the tank.
Kohler Co.
Supply
Support Blocks
Waste Stack
7
Connect
supply.
1095641-2-B