Related Manuals for FHF Avisa AX04
Summary of Contents for FHF Avisa AX04
- Page 1 Sounder AX04 and Sounder-Strobe-Combination AXL04 AX04 AXL04 Dimensions AX04 Dimensions AXL04 FHF B 6033-10 04/11...
- Page 2 Installation mounting holes. 20 mm cable entries are provided on all sides and in the base. To maintain the integrity of the The sounder or combined sounder strobe units can be weather seal, the cable entry must be via a suitable affixed to most surfaces using screws through the holes sealed gland.
- Page 3 Sound selection table First and Second Stage Frequency / Rept. Switches Special rate 1 2 3 4 5 Application 1 Alternate two-tone 800 - 1000 1 1 1 1 1 Fire Alarms 2 Alternate two-tone 2500 - 3100 0 1 1 1 1 Security Alarms 3 Alternate fast two-tone 800 - 1000...
-
Page 4: Sound Selection
Figure 1 Figure 2 DC Input - second stage with third wire DC Input - second stage by supply reversal Line integrity: monitor via reverse polarity Line integrity: monitor via threshold (applied voltage 1 V) An end-of-line (E.O.L) resistor is required for line monitoring and it should be a minimum resistance of 3K3 ohms and 0.5 watts. -
Page 5: User Information
User information 1. The appliance has been designed for insulation class II and is only to be connected to, and operated with, the specified voltage. Specifications of polarity must be observed. 2. Ensure that the casing is not damaged. 3. The relevant codes of Practice an Trade Association requirements for save operation must be observed. 4. - Page 6 Subject to alterations or errors FHF Funke + Huster Fernsig GmbH Gewerbeallee 15-19 · D-45478 Mülheim an der Ruhr Phone +49 / 208 / 82 68-0 · Fax +49 / 208 / 82 68-286 http://www.fhf.de · e-mail: info@fhf.de...