Advertisement
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
Tray mount assembly
Tray
Pin
Support bracket
Bolt (5/16 x 2-1/4)
Flange nut (5/16 inch)
Bolt (5/16 x 1 inch)
Self tapping bolt (5/16 x 3/4 inch)
Support rod
Flat washer
Hairpin cotter pin
Installing the Carrier
1. Install one bolt (5/16 x 1 inch) through the pin
assembly clip.
2. Using the top 2 holes, install the tray mount assembly
and pin assembly to the machine using 2 bolts (5/16 x
1 inch) and 2 locknuts (5/16 inch) (Figure 1).
3. Install the tray mount assembly to the bottom of
the machine using 2 self tapping bolts (5/16 x 3/4
inch)(Figure 1).
4. Install the support bracket to the tray mount assembly
with 2 bolts (3/8 x 2-1/4) and 2 locknuts (5/16 inch)
(Figure 1).
6
7
8
5 4
3
1. Lock nut (5/16 inch)
2. Machine frame
3. Tray mount assembly
4. Bolt (5/16 x 1 inch) (use
the top 2 holes)
1 2
Figure 1
5. Pin assembly
6. Bolt (5/16 x 2-1/4 inch)
7. Support bracket
8. Self tapping bolt (5/16 x
3/4 inch)
Qty.
1
1
1
1
2
4
Install the carrier.
2
2
2
2
2
5. Slide the end of the support rod, without the hole, into
the key slot in the frame (Figure 2).
6. Install the other end of the support rod through the
support bracket and secure with a flat washer and a
hairpin cotter pin (Figure 2).
7. Repeat for the opposite side.
g021 139
1. Support bracket
2. Hairpin cotter pin
3. Flat washer
g021 176
2
Use
1
2 3
4
5
Figure 2
4. Support rod
5. Key slot in machine frame
Advertisement
