Table of Contents
Advertisement
-
ENGLISH VERSION
-
GENERAL INSTALLATION AND MAINTENANCE INSTRUCTIONS
AIRMIL'S G with SCREW compressor
Regulation by MILLENIUM control device
SAFETY RULES see manual n°511927 / Spare parts list and maintenance instructions for compressors
This document must not be disclosed or reproduced without permission from MIL'S.
Failure to respect this requirement may lead to prosecution.
-
08/17 – NOTICE N° 515910 VERSION 12
-
Advertisement
Table of Contents
Related Manuals for MIL'S MVX 2
Summary of Contents for MIL'S MVX 2
- Page 1 Regulation by MILLENIUM control device SAFETY RULES see manual n°511927 / Spare parts list and maintenance instructions for compressors This document must not be disclosed or reproduced without permission from MIL'S. Failure to respect this requirement may lead to prosecution.
-
Page 2: Table Of Contents
Particular maintenance instructions AIRMIL'S G with SCREW compressors Regulation by MILLENIUM control device CONTENTS SECTION 1. INTRODUCTION 1.1............................... 3 PECIFICATION PLATES SECTION 2. CHOICE OF ROOM 2.1..............................4 OOM VENTILATION SECTION 3. DESCRIPTION WITH SCREW COMPRESSOR 3.1..........................5 CHEMATIC DIAGRAM EXAMPLES 3.2. - Page 3 Particular maintenance instructions AIRMIL'S G with SCREW compressors Regulation by MILLENIUM control device MEANING OF SYMBOLS USED IN THESE INSTRUCTIONS Symbols are used in these instructions to help you understand them and to indicate particular points which you need to act upon or consider. Those symbols are: Reading symbol: to refer to the operator manual / instructions manual.
-
Page 4: Introduction
Particular maintenance instructions AIRMIL'S G with SCREW compressors Regulation by MILLENIUM control device SECTION 1. INTRODUCTION Please read the start-up instructions carefully before commissioning the air plant. Damages resulting from improper implementation or installation shall not be covered by the warranty. It is recommended, in order to facilitate your subsequent orders for spare parts (if required) and for any information requests concerning your air plant, to write on this page the characteristics which are marked on the identification plates on each one of the main components of your air station, as soon as you receive the equipment. -
Page 5: Choice Of Room
Particular maintenance instructions AIRMIL'S G with SCREW compressors Regulation by MILLENIUM control device SECTION 2. CHOICE OF ROOM The unit must be located in a clean, non-humid, non-saline, dustless and ventilated local whose the temperature should be between +5C and +40C. Forced ventilation controlled by a thermostat must be installed to ensure adequate room ventilation. -
Page 6: Description With Screw Compressor
Regulation by MILLENIUM control device Compressor Heart release Air inlet section Exhaust fan Exhaust air Power (kW) type (kCal/h) (m²) (m³/h) duct (mm) MVX 2 1 892 0,10 1 000 MVX 3 2 580 0,10 1 200 MVX 4 3 440 0,10 1 500... -
Page 7: Description Of The Air Production Line
Particular maintenance instructions AIRMIL'S G with SCREW compressors Regulation by MILLENIUM control device 3.1.2. Mechanical architecture: two compressors associated with an air treatment unit SCREW COMPRESSOR DRYER by - Adsorption PRESSURE Receiver FINAL FILTER NETWORK - Refrigeration REDUCER - Filters SCREW COMPRESSOR Control device... -
Page 8: Description Of The Operation Of The Air Production Line Starting From Two Compressors
Particular maintenance instructions AIRMIL'S G with SCREW compressors Regulation by MILLENIUM control device 3.2.5. Final filtration Final filtration stops the residual particles present in the network and the receiver. 3.2.6. MILLENIUM control device If the line of production includes one compressor, then, there doesn't need MILLENIUM control device. The compressor is only controlled. -
Page 9: Installations
Particular maintenance instructions AIRMIL'S G with SCREW compressors Regulation by MILLENIUM control device 3.3.4. Compressor alarm From each compressor, a general alarm has to be connected in the MILLENIUM control device. This alarm is the synthesis of the following situations: Motor disjunction, Too high oil temperature, Compressor power off,... -
Page 10: Dimensions For Pressure Reducing Valve Outlet
Particular maintenance instructions AIRMIL'S G with SCREW compressors Regulation by MILLENIUM control device 4.6. Dimensions for pressure reducing valve outlet 4.6.1. Pressure reducer alone BP300 BP500 / BP800 4.6.2. Simple, parallel duplex and parallel triplex final filtration CMP 53 S CMP 106 DP CMP 159 TP CMP 162 S... -
Page 11: Electric Power Supply And Control For Screw Compressor
Particular maintenance instructions AIRMIL'S G with SCREW compressors Regulation by MILLENIUM control device Simple version Parallel duplex version Version simple Version duplex parallèle ØE ØE ØE ØE Parallel triplex version Version triplex parallèle Weight ØE ØE ØE DCMP 53 S 1/2"... -
Page 12: Power Supply And Control Of The Air Drier By Adsorption
Particular maintenance instructions AIRMIL'S G with SCREW compressors Regulation by MILLENIUM control device -of the length -of the room temperature -of the wire path Alarm report: The connection between Alarm report on automate units must be done by the person in charge of the Installation. -
Page 13: Connections
Particular maintenance instructions AIRMIL'S G with SCREW compressors Regulation by MILLENIUM control device SECTION 5. CONNECTIONS 5.1 Installation of AIRMIL’S units, type G The AIRMIL’S air compressor packages in G configuration are delivered as separate elements which must be connected on site by the installer or the client. The diagram below shows the connection operations to be carried out: The connecting hoses between the compressors and the dryers are provided by the MIL’S SAS Company. -
Page 14: Optionnal Tank
Particular maintenance instructions AIRMIL'S G with SCREW compressors Regulation by MILLENIUM control device 5.3. Optionnal tank If the operator takes charge of supplying the storage tank, it must be adapted to the nominal working pressure of the facility and must bear the CE marking in compliance with directive 2014/68/UE (equipment under pressure) or 2014/29/UE (simple pressure vessels). -
Page 15: Identification And Traceability
Particular maintenance instructions AIRMIL'S G with SCREW compressors Regulation by MILLENIUM control device The entire facility must undergo a final verification before commissioning. Standard NF EN ISO 7396-1 applicable to medical gas distribution systems details the tests to be carried out. The results of the verifications must be recorded and kept. -
Page 16: Running Operation
Particular maintenance instructions AIRMIL'S G with SCREW compressors Regulation by MILLENIUM control device SECTION 6. RUNNING OPERATION 6.1. First step ⇒ Check the oil level of compressors. ⇒ Before starting the equipment, first read all the running operation and maintenance manuals attached to this one (screw compressor, ADSORMIL'S air dryer, SEC F air dryer,...). -
Page 17: Safety Valve
Particular maintenance instructions AIRMIL'S G with SCREW compressors Regulation by MILLENIUM control device To avoid risk of damage or prevent equipment become dangerous is essential use the compatible components provide by the manufacturer. 3 years 5 years months month months months Refer to the commissioning and maintenance manual COMPRESSOR... -
Page 18: Receivers (Provided By Mil's)
TRAINING In order to ensure perfect aptitude in the use of the oxygen concentrator, the MIL'S Company offers its own training for the use of this equipment. It is intended for users and technical personnel working on or near the air production plant. -
Page 19: Section 11. Electromagnetic Compatibility
Particular maintenance instructions AIRMIL'S G with SCREW compressors Regulation by MILLENIUM control device SECTION 11. ELECTROMAGNETIC COMPATIBILITY The AIRMIL’S units networks with MILLENIUM automate needs special precautions regarding EMC. The AIRMIL’S units networks with MILLENIUM automate has to be installed and put into service according to the EMC requirements joined in the following tables Guidance and manufacturer’s declaration –... - Page 20 Particular maintenance instructions AIRMIL'S G with SCREW compressors Regulation by MILLENIUM control device Guidance and manufacturer’s declaration – electromagnetic immunity - for ME equipment and ME systems that are not life- supporting The AIRMIL’S units networks with MILLENIUM automate is intended for use in the electromagnetic environment specified below. The customer or the user of the AIRMIL’S units networks with MILLENIUM automate should assure that it is used in such an electromagnetic environment.
- Page 21 Particular maintenance instructions AIRMIL'S G with SCREW compressors Regulation by MILLENIUM control device automate can be affected by communication portables or mobiles RF’s The AIRMIL’S units networks with MILLENIUM equipment. Recommended separation distances between portable and mobile RF communications equipment and the AIRMIL’S units networks with MILLENIUM AUTOMATE The AIRMIL’S units networks with MILLENIUM automate is intended for use in an electromagnetic environment in which radiated RF disturbances are controlled.
- Page 22 __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________ __________________________________________________________________________________________...
- Page 24 www.mils.fr...
Need help?
Do you have a question about the MVX 2 and is the answer not in the manual?
Questions and answers