UTStarcom WA3003G4 User Manual page 12

8 Chapter 2 WA3003G4 Installation
You can attach a telephone line to the device. This is helpful when the VDSL line uses the only
convenient wall phone jack. If desired, connect the telephone cable to the port labeled PHONE.
Step 2. Connect the Ethernet cable.
If you are connecting a LAN to WA3003G4, attach one end of a provided Ethernet cable to a
regular hub port and the other to the Ethernet port on WA3003G4.
Step 3. Attach the power connector.
Connect the AC power adapter to the DC-IN connector on the back of WA3003G4 and plug in the
adapter to a wall outlet or power strip.
Step 4. Turn on the WA3003G4 and power up your systems.
Press the Power switch on the back panel of the device to the ON position.
Turn on and boot up your computer(s) and any LAN devices such as hubs or switches.
Step 5. Configure the WA3003G4 through the WEB interface
The detail step3 would be described in Chapter3. It would help you configure the WA3003G4 to
meet your need.
Step 6. Save the configurations and Reboot.
To make the settings you made on WA3003G4 take effect.
Although you use the same type of
cable, The VDSL and PHONE ports
are not interchangeable. Do not
route the VDSL connection through
WARNING
the PHONE port.