Advertisement
Others in the workplace should be kept at a safe distance from the drill, especially when it is in operation.
Keep the work area as childproof as possible by using padlocks and master switches.
3
Keep drill bits clean and sharp for best and safest performance. Follow the instructions for lubrication and changing accessories.
3
Remove ill fitting clothing. Remove ties, watches, rings and other loose jewellery and contain long hair.
3
Locate the drill in a suitable working area, keep area clean and tidy and free from unrelated materials. Ensure there is adequate lighting.
3
Maintain correct balance and footing. Ensure the floor is not slippery and wear non-slip shoes.
3
3 Avoid unintentional starting.
3
DO NOT use the drill for a task it is not designed to perform.
DO NOT allow untrained persons to operate the drill.
7
DO NOT get the drill wet or use in damp or wet locations or areas where there is condensation.
7
DO NOT operate the drill if damaged.
7
DO NOT use drill in an area where paint fumes, solvents or flammable liquids pose a potential hazard. Keep flammable material away from
7
the drill when operating. Flammable waste, such as wipes or cleaning rags, must be placed in a closed metal container and disposed of correctly.
7
DO NOT exceed the rated capacity of the drill.
DO NOT operate the drill if any parts are missing as this may cause failure and/or personal injury.
7
DO NOT leave the drill operating unattended.
7
DO NOT operate the drill when you are tired, under the influence of alcohol, drugs or intoxicating medication.
7
DO NOT pull the cable from the power supply.
7
When not in use switch the drill off, remove plug from the power supply and do not leave until the tool has come to a complete stop.
7
3
2. DESCRIPTION
The GDM250F 12 speed floor drill is suitable for light industrial, agricultural and woodworking applications. The drill is fitted with flip-up
safety guard and “No Volt Release” switch which prevents accidental restart after a mains power interruption. A rack and pinion feed shaft with
preset depth control for repetitive work and a Morse Taper Spindle to accept taper shank bits are also included. Work clamps are
also available for this drill, contact your local Sealey dealer for information.
3. TECHNICAL SPECIFICATIONS
Model
Chuck size (mm)
Spindle Nose Taper
Swing (mm)
Chuck to Upright Face (mm)
Spindle Travel (mm)
Number of Speeds
Speed Range (rpm)
Spindle to Table - max. (mm)
Spindle to Base - max. (mm)
Working Table Diameter (mm)
Working Base (mm)
Overall Base (mm)
Column Diameter (mm)
Overall Height (mm)
Voltage (AC)
Motor Range - no load (W)
- under load (W)
Weight (kg)
4. CONTENT
4.1. Content
Check the parts against the list below. If any items are damaged or missing contact your supplier immediately.
3 Head Assembly
3 Column with Flange
3 Adjusting Handle with Set Screw (table)
3 Pivoted Clamp Bolts (2 - table arm & bracket)
3 Safety Guard
3 Wedge
GDM250F
19
MT4
650
279
122
12
210 - 2160
720
1230
375
230 x 250
330 x 580
92
1780
230
1100
1190
155
3 Base
3 Feed Handles and Knobs (3)
3 Table
3 Bolts and Washers (4)
3 Arbor
3 Hex. Keys (2)
3 Chuck and Key
3 Table Arm, Bracket and Worm
3 Rack and Rack Ring
3 Screw (upper pulley cover)
3 Set Screws (2)
GDM250F - 0016 - (2) - 111000
Advertisement
