Citizen H10 Series Abbreviated Instruction

English
• This watch is solar-powered. Expose the dial to light and use it sufficiently charged.
• To see details of charging time, specifications and operations, refer to the instruction manual.
Component identification
Reception-in-progress
Reception result
indication (RX)
indication (NO)
Hour hand
Second hand
• Actual appearance may differ from the illustration.
• The crown has two positions when pulling it out.
Checking the signal reception result
• This watch receives the time signal from the Japan station every day to adjust
time automatically.
1. Push the crown in to position
2. Press and release the lower right button
The second hand moves to indicate the result of the last reception.
Indication
H
The reception was successful in a very good condition.
M
The reception was successful in a good condition.
L The reception was successful in a not-good condition.
NO The reception failed.
• Try signal reception following the steps in
(on-demand reception) if the last reception failed.
3. Press and release the lower right button
procedure.
The indication returns to current time.
• It returns to current time indication automatically in about 10 seconds
without pressing the button.
Receiving the signal manually (on-demand reception)
• It takes 2-15 minutes to finish reception.
1. Push the crown in to position
2.
Press and hold the lower right button
The second hand points "RX" and signal reception starts. The second hand
returns to normal movement after finishing reception.
Reception was successful The time will be updated.
The time is not corrected and the previously set time
Reception failed
resumes.
A
• Press and hold button for 2 seconds or more to cancel reception.
H10* Abbreviated instruction
Reception result
indication (H/M/L)
B
Button
Crown
Date/day-of-week
indication
A
Button
Minute hand
Crown's position
0 1 2
0 .
A
.
Reception result
Receiving the signal manually
A
to finish the
0 .
A
for 2 seconds or more.
Adjusting the time and calendar manually
Setting the time
1. Pull the crown out to position
The second hand points 0 second.
2.
Rotate the crown to adjust time.
• When you rotate the crown quickly a few times, the hand will move
continuously. To stop the rapid movement, rotate the crown in either
direction.
• The hour and minute hands move synchronously.
• Change of date indication shows it just became AM. Take care the time set
is AM or PM.
3. Push the crown in to position
time source to finish the procedure.
Setting the calendar
1. Pull the crown out to position
The second hand indicates year and month currently set.
2. Press and release the lower right button
change the indication to be corrected.
• Each time you press button
Date → day of week → year/month →(back to the top)
3. Rotate the crown to adjust indication.
• Each time you press button
week indication switches between Japanese and English.
• Year and month are indicated with the second hand.
"Month" corresponds to one of
the 12 zones shown in the figure
below.
Each number means month.
12
11
1
10
9
8
7
5
6
4.
Repeat steps 2 and 3.
5. Push the crown in to position
1/2
.
2
0 in accordance with a reliable
1 .
A
repeatedly to
A
, the target changes as follows:
B
during day-of-week adjustment, the day-of-
"Year" corresponds to the years
since leap year and is indicated
with markers in the zone of each
month.
Years since leap year: 0 (Leap
year)
Years since leap year: 1
Years since leap year: 2
2 Years since leap year: 3
3
4
to finish the procedure.
0
0
1
2
3