Advertisement
INSTALLATION
• Install the Channel Extension Module
1. Attach the supplied angles to both sides of the channel
extension module, and tighten the 2 supplied screws (M4×8
mm) on each side.
2. Install the channel extension module using the supplied screws
(Tapping screws: M3×8 mm, Set screws: M3×6 mm) as shown
below.
Channel extention
module
Channel module
(original)
• Connect the control cable
1. Connect the supplied control cable to J502 on the front board as
shown below.
2. Cut the rubber caps of the control cables, then insert the rubber
caps to the front panel's chassis as shown below.
q
w
J502
ASSEMBLING THE UNIT
1. Replace the rubber seal and shielding plate of the front panel,
then tighten the 6 screws.
• Make sure the rubber seal is properly seated in the groove of
the chassis.
• Be sure to match the correct positions of the holes of the
shielding plate and projections of the front panel's chassis.
Set screws
Tapping
screws
2. Connect the control cables to the channel modules.
Channel module
(original)
Holes
Rubber seal
Projections
Channel extention module
Longer cable
(upper side)
Shorter cable
P 0
P 1
P 2
P 3
P 4
(lower side)
3. Return the front panel, top cover and screws to their original
positions.
P 0
P 1
P 2
P 3
P 4
P 0
P 1
P 2
P 3
P 4
Advertisement
