After Installation - LG OLED97G2CUA Manual

Hide thumbs

Table Of Contents

Table of Contents

• When tightening screws, tighten until fully snug.

Avoid using excessive force when tightening the screws. Doing so may

damage the wall and product or reduce the rigidity or performance of

the product.

• Avoid installing a TV that exceeds the specified tensile load, and do not

allow any external force to be applied to the product.

• Avoid accidents by using work tools with care during installation.

Tools for Installation

• "+" shaped screwdriver (manual or electric) / level / drill / Ø 8 mm drill

bit for concrete or Ø 4 mm drill bit for steel

Securing TV to the Wall

(Except for OLW480B, LSW440B, LSW640B)

• Please use the TV close to the wall after installation.

How to fix anchors and screws

(Except for OLW480B, LSW440B, LSW640B)

Please make sure that:

• Check that the material and thickness of the wall and finishing material

comply with the installation manual. Before beginning the mounting

process, you must be sure the wall is able to support the weight of the

TV.

• Should use the enclosed anchors and screws on crack-free concrete walls.

• Never install the product on a plasterboard or wall made of paper or

medium-density fiberboard (MDF). When it is necessary to install the

product on such wall, anchor screws must be fastened to retaining walls

(concrete) or wood Stud inside the finishing material.

• The wall mount should be attached to a stud. This usually will not be a

problem, but depending upon individual circumstances, there may be

cases when the ability to mount into a stud is not possible. In this case,

there are a variety of drywall anchors, such as toggle bolts, which may

provide a solution. If using drywall anchors, please be sure the anchors

and the wall have the ability to support the weight of your TV. Please

note that the supplied anchors may not be the correct ones for your

individual situation, so you should check with a local professional.

• Other unspecified walls must be capable of supporting pullout loads of

over 70 kgf (154 lbf) (686 N) and shear loads of over 100 kgf (220 lbf)

(980 N) per fastener.

• Use an Ø 8 mm drill bit for concrete and a hammer (impact) drill or Ø

4 mm drill bit for wood stud to drill holes.

For installation on concrete wall

Wall mounting anchor

Wall mounting screw

1 Drill holes in anchor locations with a drill bit of Ø 8 mm to a depth of

80 mm (3.14 inches) to 100 mm (3.93 inches).

2 Clean the drilled holes.

3 Insert the enclosed anchors for fixing the wall mount into the holes. (Use

a hammer when inserting anchors.)

4 Push the wall mount support closely toward the wall to match the hole

locations.

5 Tighten screws for fixing the wall mount to the holes. At this time, tighten

the screws to a torque of between 45 kgf/cm (39.06 lbf/in) to 60 kgf/cm

(52.08 lbf/in).

For installation on wood stud

76 mm (2.9 inches)

Use the Ø 4 mm drill bit for wood to drill holes with the depth of 76 mm (2.9

Inches). (Clean the drilled hole.)

Without using the wall mounting anchor, fasten the wall mounting screw

directly to the wood stud.