Related Manuals for Harrod GFC-128
Summary of Contents for Harrod GFC-128
- Page 1 HEAVY-DUTY STEEL PEAKED DECORATIVE FRUIT CAGE ASSEMBLY AND INSTALLATION INSTRUCTIONS PRODUCT CODE: GFC-128/129 Revision 5 If you wish to concrete your cage in place please see page 8. For more information on our cages please follow the below link:- INS 809...
-
Page 2: Part Identification
PART IDENTIFICATION PAGE 2... - Page 3 DECORATIVE FRUIT CAGE ASSEMBLY INSTRUCTIONS Introduction Thank you very much for purchasing this Harrod Horticultural Decorative Fruit Cage. These instructions show the step by step assembly of a three unit cage which will help demonstrate how to install your fruit cage, regardless of whether you have bought a single, or a multiple unit cage.
- Page 4 DECORATIVE FRUIT CAGE ASSEMBLY INSTRUCTIONS 1. After reading the introduction, 2. Decide where the door(s) should go 3. Using the correct connector (ref. lay out on the ground in the desired (see step 9) and slide a T-joint (ref. 6) 15,16 &...
- Page 5 DECORATIVE FRUIT CAGE ASSEMBLY INSTRUCTIONS Refer to diagram on page 2 10. With the aid of a mallet and a stake, 11. Place the uprights (ref.4) into the 12. Before attaching the roof unit to carefully create appropriately sized holes and at the same time slide on the uprights ensure that two hinge holes in the ground about 32.5cm deep the foot plates (ref.13) as shown.
- Page 6 DECORATIVE FRUIT CAGE ASSEMBLY INSTRUCTIONS Refer to diagram on page 2 19. Your cage should now in essence 20. The door frame(s) can be 21. On side(s) of the cage that door(s) resemble the above example, with all assembled using the diagram on page are located, measure from the ground horizontal bars and connector plates in 2 to assist you.
- Page 7 DECORATIVE FRUIT CAGE ASSEMBLY INSTRUCTIONS 28. Bolt (ref. 22 & 23) the curved roof 29. Tighten the bolts using a 17mm 30. Place the assembled door frame supports (ref. 24) onto the connector spanner. in position and secure in by joining the hinge blocks (Ref.8) as shown and plates (ref.
- Page 8 DECORATIVE FRUIT CAGE ASSEMBLY INSTRUCTIONS 37. Trim the net level with the top of the 38. Secure the net to the door using 39. Using net ties (ref. 27) passed door as shown. Any side net sticking ties (ref. 27) as shown. through the slots provided in the up above the top edge of the 2.5m connector plates, secure the ftted...
- Page 9 DECORATIVE FRUIT CAGE ASSEMBLY INSTRUCTIONS 46. Tie in the sides of the roof net(s) 46. With the whipping needle loaded 47. Walk around the perimeter of your to the horizontal bars and side net by with twine, tie one end of the twine cage and insert ground pegs (ref.
- Page 10 DECORATIVE FRUIT CAGE ASSEMBLY INSTRUCTIONS Concreting your Cage In most cases uprights will not require concreting in place. However if you require extra rigidity you may prefer to secure the uprights with concrete. Ground 0.15m x 0.15m holes can be dug to the 32.5cm required depth at 0.15m 0.15m...