Mojave V3 Instruction Sheet

Dry Vacuum System

Introduction

This document provides instructions for using replacement kits (P/N H5213, H5215, H5617) and refurbished kits (P/N H5213R,
H5215R, H5617R) to replace a vacuum pump assembly of a MOJAVE Dry Vacuum System. Use the replacement or refurbished
kit corresponding to the MOJAVE vacuum pump being replaced as follows.
MOJAVE pump Kit Part No.
V3 H5213
V5 H5215
V7 H5617
V3 H5213R
V5 H5215R
V7 H5617R

Important Information

Service Personnel

Power Removal

Pump Replacement Procedure

Replace the faulty vacuum pump using the correct replacement or refurbished pump by performing the following steps.
1. Make sure to remove all mains power
before performing any replacement
procedures.
2. Using a #2 Phillips screwdriver, remove the
cover from the electrical connection box.
3. Disconnect the green with yellow stripe
ground wire using a #2 Phillips screw-
driver.
4. Disconnect the black, red and white wires.
5. Remove the strain relief and harness
assembly from the electrical connection
box of the motor.
Vacuum Pump Replacement / Refurbished Kit Components Supplied
Vacuum Pump
Assembly
All personnel servicing the MOJAVE system must read and understand the Operator's Manual
before operating or performing any service of the unit. Only a trained technician from a qualified Air
Techniques dealer should perform any service.
Never work on equipment connected to live power. Remove power by disconnecting mains
power to the unit prior to performing any replacement procedures.
V3, V5 & V7 Vacuum Pump Assembly
Replacement / Refurbished Kits
Part Nos: H5213, H5213R, H5215, H5215R, H5217 & H5617R
INSTRUCTION SHEET
Flange
Gasket
5 mm Hex
Wrench
Electrical
Connection
Box

Electrical Connection Box Location and Connections

Inlet Filter
Gasket
Inlet Filter
Screen
Inlet Filter
Bowl