Table of Contents
Advertisement
1
1
10
Number buttons and other component controls
Use the number buttons to directly select a radio frequency
(page
32) or the tracks on a CD, etc. There are other buttons
that can be accessed after
is pressed. (For example
RECEIVER
MIDNIGHT, etc.)
– Press to switch on/off Acoustic Calibration EQ
EQ
setting
(page
34).
– Press to switch on/off Phase Control
PHASE
– Press to select the audio input signal of the
SIGNAL SEL
component to play back
(page
25).
– Press to restore CD quality sound to
S.RETRIEVER
compressed audio sources
(page
34).
– Press to select ON, AUTO or OFF the surround
SB CH
back channel
(page
35).
– Press repeatedly to select a channel, then
CH SELECT
use
to adjust the level
(page
LEV +/–
– Use to adjust the channel level.
LEV +/–
– Switches to Midnight or Loudness listening
MIDNIGHT
(page
36).
– See
Switching the speaker terminal on
SPEAKERS
page
13.
– Dims or brightens the display. The brightness
DIMMER
can be controlled in four steps.
11
SOURCE
Press to turn on/off other components connected to the
receiver
(page
55).
12
TV CONTROL buttons
These buttons are dedicated to control the TV assigned to the
button. Thus if you only have one TV to hook up to this
TV
system assign it to the
button
(page
56).
TV
– Use to turn on/off the power of the TV.
– Use to select the TV input signal.
INPUT
– Use to select channels.
CH +/–
– Use to adjust the volume on your TV.
VOL +/–
13
+Favorite
Press while a song is being played back or stopped. The
selected song is then registered in the Favorites folder
(page
40).
14
VOLUME +/–
Use to set the listening volume.
15
MUTE
Mutes/unmutes the sound.
16
DISP
Switches the display of this unit. The listening mode, sound
volume, Speaker System setting or input name can be
checked by selecting an input source.
•
The Speaker System setting may or may not be displayed,
(page
35).
depending on the input source you have selected.
17
SHIFT
This button is used for operating ZONE 2
Loading the batteries
48).
The batteries included with the unit are to check initial
operations; they may not last over a long period. We
recommend using alkaline batteries that have a longer life.
CAUTION
•
Incorrect use of batteries may result in such hazards as
leakage and bursting. Observe the following precautions:
Never use new and old batteries together.
-
Insert the plus and minus sides of the batteries properly
-
according to the marks in the battery case.
-
Batteries with the same shape may have different
voltages. Do not use different batteries together.
When disposing of used batteries, please comply with
-
governmental regulations or environmental public
institution's rules that apply in your country or area.
-
Do not use or store batteries in direct sunlight or other
excessively hot place, such as inside a car or near a
heater. This can cause batteries to leak, overheat,
explode or catch fire. It can also reduce the life or
performance of batteries.
Operating range of remote control
The remote control may not work properly if:
•
There are obstacles between the remote control and the
receiver's remote sensor.
•
Direct sunlight or fluorescent light is shining onto the
remote sensor.
•
The receiver is located near a device that is emitting
infrared rays.
•
The receiver is operated simultaneously with another
(page
54).
infrared remote control unit.
10
Controls and displays
30°
30°
7 m (23 ft.)
Advertisement
Table of Contents
