Span Calibration Network Address Alarm settings Set Zone Menu Structure Overview (continued) Page 9 Advanced Options Password Factory reset Select signal type Select sensor type Select Gas Set Units Set sensor range Contact Details Page 10 HGD SL Series Ver. 1.0...
If this product is used in countries outside of the European Union, the standards and regulations valid in these countries must be observed. Warranty All Helio Gas Detection products carry a 12 month warranty. Damage caused to products by improper transportation, handling and / or installation are not subject to warranty.
Use ferrules if using stranded cables. PCB terminal blocks up to 2.5mm2. Use twisted pair cable with overall screen when connecting RS485 network. *Note: All communication and data transmission between transmitters and control panel carried out via RS485 network or 2-3 wire 4-20mA interface. HGD SL Series Ver. 1.0...
Helio Gas Detection systems must be inspected and serviced regularly by trained service personnel. We recommend that a service contract be obtained with a HELIO Gas Detection approved vendor and that all repairs also be carried out by them. Only authentic HELIO components may be used for maintenance purposes.
Overview The Helio SL gas detector is provided with an internal 2 x 8-character LCD display, with an “M” menu button and both “Up” and “Down” push buttons to navigate through the program menus. During normal operation the internal LCD display shows the current gas concentration and alarm status if activated.
SL detector menu structure, calibration menu, alarm setpoints etc. Note: these settings may not be suitable for every application. Consult with Helio Gas Detection representative prior to installation. Upon order, the gas type and signal configuration should be specified, so that the SL detector can be shipped preconfigured.