Rompa 20438 Manual

Page 1 of 2
SOUND & MASSAGE WATER BED 20438
PLEASE NOTE: A COMPLETE MANUAL IS INCLUDED WITH THE PRODUCT
– THIS IS ONLY A BRIEF INDICATION OF THE INSTALLATION PROCESS

CONTENTS

Water bed with integrated massage and sound module
Controller
Please note: This product requires, but does not include, an audio source e.g. DVD player,
sound system etc

BEFORE USE

1. Choose a suitable location, bearing in mind that your music system will need to be
plugged in, as will the Massage Water Bed
2. Assemble the base frame with aluminium corners (as indicated below by the number 1).
3. The side with the opening for the amplifier can be placed on the left or right hand side of
the bed depending on the side from which the system is to be operated (see 2 below).
4. Position the stabilisers inside the base as shown.
5. Add rubber tape to the surfaces of the stabilisers and base frames. It will help fastening
the base boards (see 3 below).
6. The vibrators are already integrated in the base board and ready for use. Place the base
boards with sound system at the head end and lead the connection cable to the opening
in the base side. Be careful not to place the vibrators on the stabilisers. (The vibrators
will be placed under the back).
7. Connect the cable from the vibrators with the cable from the amplifier (see 4 below) and
fasten the amplifier module in the opening. Plug the in the system and test whether the
sound system is properly installed and works before the rest of the waterbed is mounted.
Please note: Please be careful that the heating element does not cover the sound
system in the base board.
SOUND & MASSAGE WATER BED 20438, KH 1.11
Copyright ROMPA® Ltd