Advertisement
TM
Wireless Remote Control Air Pump Instruction Manual
Congratulations, and thank you for purchasing the leading replacement air
system for luxury air mattresses. We know you will be pleased with the
quality and performance of your investment. Your new REM Air System
boasts the newest in remote sensor and whisper technology. In addition
you will also be happy with the simplistic setup and user friendliness.
Technical Specifications:
Model: REM Air System replacement pump
Voltage: DC12V
Pressure: 0-60mbar (Show 1-20 numerical value)
Flow: 20LPM
Power: 25W
Standby Power: 2W
Weight: 2.3Kg
Contour Dimension: Length 260* Wide 155* Height 105mm
Advertisement
Table of Contents
Related Manuals for Rem Air System replacement pump
Summary of Contents for Rem Air System replacement pump
- Page 1 Congratulations, and thank you for purchasing the leading replacement air system for luxury air mattresses. We know you will be pleased with the quality and performance of your investment. Your new REM Air System boasts the newest in remote sensor and whisper technology. In addition you will also be happy with the simplistic setup and user friendliness.
- Page 2 Inflate Memory Left & Right Conversion Deflation Operational Instructions: 1. Power on by connecting power source into outlet and plugging opposite end into the pump input receiver. Pump LED light will show red for 30 seconds after initial start. When the LED light turns green;...
- Page 3 “Er.” Please use within rage. Upon initial installation of your REM Air System; if your remote reads “Er,” and your are within the allotted rage of 5 to 10 meters, no problem. This simply means the remote needs to be calibrated with the pump.
Need help?
Do you have a question about the Air System replacement pump and is the answer not in the manual?
Questions and answers
My remote is reading 0 despite the bed being inflated. If I try to increase the pressure. The pump will activate for a second or two then shuts off. I have tried to recalibrate the remote but the red LED on the pump won’t stay on for more than 2 seconds before turning green. Not sure how to proceed.
If the REM Air System replacement pump activates briefly and the remote reads 0, you may need to recalibrate the system. Follow these steps:
1. Ensure the power connection is secure.
2. Check the remote batteries and replace them if needed.
3. Attempt recalibration by following the instructions in the manual.
4. If the LCD screen shows "Su" after recalibration, the system is ready for use.
If the issue persists, consider resetting the system by disconnecting and reconnecting the power.
This answer is automatically generated