Table of Contents
Advertisement
Using Your Steam Pocket
Mop
®
IMPORTANT: Make sure you do not use the Steam Mop without attaching a Dirt Grip
water to the water tank first. When you are using the Steam Mop for the first time, it might take longer
than the normal 30 seconds to start steaming.
IMPORTANT: Do not use on unsealed wood or unglazed ceramic floors. On surfaces that have been treated
with wax and on some no-wax floors, the sheen may be removed by the heat and steam action. Test an
isolated area of the surface to be cleaned before proceeding. Check the use and care instructions from the
floor manufacturer.
fig. 9
fig. 10
NOTE: To prolong the life of your Steam Mop, we
recommend using distilled water.
NOTE: Sweep or vacuum your floors prior to
cleaning with your Steam Mop.
1
Twist the Quick-Release Cord Holder to unwrap
the power cord completely (fig. 9). Plug into an
electrical outlet. The blue light will illuminate. It takes
approximately 30 seconds for the Steam Mop to
heat up.
2
Pump the handle a few times, pushing the handle
toward the mop head in a downward, fast pumping
motion. This pumping action will release steam
as you mop with a forward or backward motion.
Customize the amount of steam by mopping slowly
for less steam and quickly for more steam.
3
Begin mopping with a forward and backward
motion. The natural motion of mopping will produce
steam.
4
When you need an extra burst of steam to clean
a stuck-on stain, you can use the Steam Blaster
feature. Flip the head over so that it is behind the
mop body, then tilt the mop handle down. This
will cause the Steam Blaster (fig. 10) to emit a
concentrated blast of steam onto the stain.
7
1-800-798-7398
pad and adding
™
fig. 11b
CAUTION: While in Steam Blaster mode, do not
leave stationary for more than one minute.
CAUTION: Do not scrub any one area for an
extended period of time.
5
To stop the Steam Blaster spray, simply raise the
handle. You can then flip the mop head back into its
original position and continue cleaning.
6
To remove the Dirt Grip pad, simply lift the Steam
Mop straight up by the handle until the Genius
Mop Head is hanging straight down. Press the
Release button on the back of the Steam Mop body
(fig. 11a), and both sides of the head will drop open,
releasing the pad (fig. 11b).
7
Once the Dirt Grip pad has been released, close the
Genius Mop Head. To close, gently press one side
of the Genius Mop Head to the floor until that side
clicks into place. Repeat on the other side.
8
When the water tank is empty, the Steam Mop will
stop producing steam. You can refill the water tank
™
at any time as long as the Steam Mop is unplugged.
Follow the water tank filling instructions on page 6.
NOTE: Please wait 2 to 3 minutes for the Steam
Mop to cool off before switching the mop head.
Never leave the Steam Mop with a damp/wet Dirt
Grip pad on any floor for an extended period of time.
Manual Steam Control
SETTING
MANUAL
Steam Blaster
™
fig. 11a
TO SANITIZE
WITH THE STEAM MOP USING THE GENIUS
*
1
Attach a clean Dirt Grip pad to the Genius Mop Head.
2
Plug into an electrical outlet. The blue light will illuminate. It takes approximately 30 seconds for the mop to heat up
and the steam to be ready.
3
Pump the handle a few times in a downward motion. This pumping action will release steam as you Steam Mop,
and allows you to customize the amount of steam you want.
4
Start mopping on an appropriate sealed hard-floor surface with a forward and backward motion. After three minutes,
your unit is ready to be used to sanitize.
5
Using a forward and backward motion, move the unit slowly and evenly over the area you seek to sanitize while
applying continuous downward pressure. Slowly repeat at least 3 times.
* Sanitization studies were conducted under controlled test conditions. Household conditions and results may vary.
Genius Mop Head only when used with Steam Mop. Not in Steam Blaster
IDEAL FOR THESE SEALED
SURFACES
Laminate
Cleaning sealed surfaces and large areas
Hardwood
Basic, everyday cleaning
Marble
Removing spots and smaller messes
Tile
Cleaning moderate and heavy traffic areas
Stone
For an extra burst of steam, you can use the Steam Blaster. Follow the instructions found on
the "Using your Steam Pocket
Mop" page.
®
MOP HEAD AND THE DIRT GRIP
™
RECOMMENDED USAGE
PAD:
™
mode.
™
sharkclean.com
8
Advertisement
Table of Contents
