Getting Started; Assembling Your Steam Pocket Mop - Shark Genius S6001W Owner's Manual

Getting Started

When assembling your Steam Mop there may be a little water in or around the water tank. This is because we test all
our Steam Mops before you buy them, so you get a quality Shark
i
j
m
l
p
q
a
Steam Mop Handle
b Quick-Release Cord Holder
c
Cord Management Clip
d
Filling Flask (clips to Steam Mop pole)
e
Spray Pocket Mop Handle
™
f Spray Bottle
g
Spray Bottle Clip
h
Steam Mop Pad Release Button
i Steam Mop Body
5 1-800-798-7398
Genius Steam Pocket Mop System.
® ™ ®
a
b
c
d
e
f g
h
k
m
n
o
j
Water Tank Lid
k Spray Pocket Mop
l
Water Tank
m
Mop Head Release Button
n
Secondary Release Buttons
o Steam Blaster Nozzle
™
p
Genius Mop Head
q
Dirt Grip Pad
™
Assembling Your Steam Pocket
fig. 2b
fig. 1
fig. 4
WARNING: Always make sure the Steam Mop
is UNPLUGGED when not in use. Never fill the
Steam Mop or attach the mop head when
the Steam Mop is plugged into an electrical
outlet. Unplug from the electrical outlet and
allow to cool before you fill the Steam Mop,
or attach or remove the head. To prolong the
life of your Steam Mop, we recommend using
distilled water. Make sure you add only water
to the tank. Chemicals or cleaning solutions
(including vinegar) may damage the Steam
Mop and could be unsafe for you and your
family.
STEAM MOP ASSEMBLY
1
Insert the Steam Mop handle into the Steam Mop
body. Push the handle in until you hear it click into
place. (fig. 1)
2 Slide the Genius Mop Head into the Steam Mop
™
body. Push until you hear it click securely into place.
(fig. 1) To detach the Genius Mop Head, press the
release button and slide off.
Mop
®
fig. 2a
fig. 3
fig. 5 fig. 6
3
To attach the Dirt Grip ™ pad, spread the pad on the
floor with the pocket side up. Center the Genius Mop
Head above the pad, then press the pad release
button on the back of the Steam Mop body. (fig. 2a)
Both sides of the Genius Mop Head will drop open.
(fig. 2b) Slip the Genius Mop Head's four corner tabs
into the four corner pockets of the pad. (fig. 3 and
fig. 4) Gently press one side of the Genius Mop Head
to the floor until that side clicks into place. (fig. 5)
Repeat on the other side. (fig. 6)
4 Pull down on the water tank lid to open. (fig. 7)
5
Use the filling flask to pour water into the water tank.
(fig. 8) Water can be poured into the tank directly.
Do not overfill past the water line on the fill flask.
Press the water tank lid firmly to close it.
fig. 7
fig. 8
sharkclean.com 6