Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for ASL INTERCOM WS-19
Summary of Contents for ASL INTERCOM WS-19
- Page 1 WS-19 SINGLE CHANNEL WIRELESS BELTPACK USER MANUAL Issue March 2011 © ASL Intercom BV DESIGNED AND MANUFACTURED BY: ASL INTERCOM BV ZONNEBAAN 42 3542 EG UTRECHT THE NETHERLANDS PHONE: +31 (0)30 2411901 FAX: +31 (0)30 2667373 WEB: www.asl-inter.com E-MAIL: info@asl-inter.com...
-
Page 2: Table Of Contents
INTERIOR .................... 5 FREQUENCY BAND & ANTENNA‟S ........... 6 SETTING UP CONNECTIONS ............6 10.0 COMMUNICATION MODES ..............9 11.0 WARRANTY ..................10 12.0 TECHNICAL SPECIFICATIONS ............10 PAGE 2 User Manual WS 19 / March 2011 © ASL Intercom BV... -
Page 3: Introduction
19 with the power switch at the rear panel, the unit should have contact with the base station. The WS-19 is used in an existing or new wireless To check this, push a CALL or TALK button. The green LED “RX active” and the red LED “1 ch. -
Page 4: Front Panel Controls
This trimmer adjusts the volume of the internal buzzer. The buzzer is activated by pushing the CALL button of the WS-19, or the CALL button of any other wired and/or wireless intercom station connected to this beltpack (see section 9) for longer than 2 seconds. -
Page 5: Rear Panel Controls & Connector
POWER on/off switch electronics of the beltpack. With this switch the battery power of the WS-19 is Use only the by ASL supplied battery switched on and off. charger. Never try to use any other adapter or charger unit. -
Page 6: Frequency Band & Antenna"S
TX/RX modules (counter clockwise) channels 2, 4, 6, 8, 1, 3, 5, 7. If one uses a WS-200 with only two beltpacks, use TX/RX channels 1 and 6 PAGE 6 User Manual WS 19 / March 2011 © ASL Intercom BV... - Page 7 LED‟s on the front panel are lit and the green LED of the corresponding TX/RX module in the base station is lit. It proofs the beltpack has connection with the base station. PAGE 7 User Manual WS 19 / March 2011 © ASL Intercom BV...
- Page 8 When two WS-400 base stations are installed and 8x WS-19 beltpacks are available: The drawing shows how to connect all WS-19 beltpacks to the same party line. PAGE 8 User Manual WS 19 / March 2011 © ASL Intercom BV...
-
Page 9: Communication Modes
The drawing shows how to connect WS-19 #1 and #2 to party line 1, WS-19 #3 and #4 to party line 2 and WS-19 #5, #6, #7 and #8 to party line 3. Example 3: When two WS-400 base stations are installed... -
Page 10: Warranty
TX/RX channel. However, only one beltpack” to return to the beltpacks. The “listening of the WS-19 beltpacks can talk at a time and beltpacks” do not hear the “talking beltpack”. have a full duplex connection. For as long as one...
Need help?
Do you have a question about the WS-19 and is the answer not in the manual?
Questions and answers