Tty Operation - Motorola RAZR V3 User Manual

receive files from another
device
Note: If you do not see the Bluetooth indicator
the top of your phone's display, turn on your phone's
Bluetooth power (see page 50).
1 Place your phone near the device, and send the
file from the device. (If necessary, refer to the
user's manual for the device for instructions.)
If your phone and the sending device don't
recognize each other, place your phone in
discovery mode so the sending device can
locate it (see page 51).
2 When prompted to accept the sent object, scroll
to Yes and press the center key
Your phone notifies you when the transfer is
complete. If necessary, press Save to save the file.
disconnect from a device
Scroll to Bluetooth and select Off.
O
a
s
.
set Bluetooth options
Find it: s
w
> Settings > Connection
> Bluetooth Link > Setup

TTY operation

You can use an optional TTY device with your
phone to send and receive calls. You must plug the
TTY device into the phone's headset jack and set the
phone to operate in one of three TTY modes.
Note: Use a TSB-121 compliant cable (provided by the
TTY device manufacturer) to connect the TTY device
to the phone.
Note: Set the phone volume to level 4 (middle setting)
for proper operation. If you experience a high number
of incorrect characters, adjust the volume as needed
to minimize errors.
Note: For optimal performance, your phone should be
at least 12 inches (30 centimeters) from the TTY
device. Placing the phone too close to the device may
cause high error rates.
connections 53