Elan EL-4KHDBT-RX-40-18G Quick Reference Manual

EL-4KHDBT-RX-40-18G
The ELAN EL-4KHDBT-RX-40-18G HDMI 2.0 4K 60Hz 4:4:4 (18Gbps) HDCP 2.2 HDBaseT ARC Receiver offers market leading features and
®
outstanding value utilizing CSC technology. The product extends HDMI, bi-directional IR & RS-232 and is powered by the matrix up to lengths of
70m (4K 40m). The receiver features ARC support when used with compatible ELAN control system hardware and simultaneous analog stereo and
Optical Toslink audio breakout.

Panel Description

Front
EL-4KHDBT-RX-40-18G
HDMI
1 2
Power Status Indicator
1
HDMI Signal Link Indicator
2
Power over Cable (PoC) Switch (On/Off) - To enable/disable
3
PoC being sent from or received by the receiver
ARC Mode Selection Switch - Alters PoC mode when used
4
with compatible ARC enabled Matrix products such as EL-
4KPM-V88-A268-18G
Optical Audio Input - Toslink audio input. Connects to the
5
optical output of the local display device for Audio Return
Channel with compatible matrix
RS-232 Port Mode Selection Switch - Firmware upgrade
6
mode or normal operating mode.

Understanding the EL-4KHDBT-RX-40-18G HDBaseT status lights

ELAN HDBaseT extender solutions include status LED indicators on both the Matrix/Transmitter and Receiver products to show all connections are
active and to help diagnose possible problems.
Understanding the Status Lights
Receiver:
• HDMI signal link light will be off when there is no connection with a display/sink
• HDMI signal link light will be on when there is an active connection with a display/sink
• HDBaseT green light will be lit if there is a stable connection between the Transmitter/Matrix and Receiver
• HDBaseT orange light will be lit when the receiver is powered by Transmitter/Matrix
Transmitter/Matrix:
• HDMI signal link light will be off when there is no connection with a source device
• HDMI signal link light will be on when there is an active connection with a source device
• HDBaseT green light will be lit when transmitting signal with HDCP
• HDBaseT green light will blink when transmitting signal with no HDCP
• HDBaseT orange light will be lit if there is a stable connection between the Transmitter/Matrix and Receiver
© 2022 ELAN is a registered trademark of Nortek Security & Control LLC. All rights reserved.
®
RevA2_QRG_ELAN_EL-4KHDBT-RX-40-18G_Working.indd 1 RevA2_QRG_ELAN_EL-4KHDBT-RX-40-18G_Working.indd 1
Quick Reference Guide
PoC ARC MODE
OPT IN NORMAL UPGRADE
ON OFF ON OFF
3 4 5 6
EL-4KHDBT-RX-40-18G
Rear
TX RX
HDBT
RS-232 IR IN IR OUT
IN
7 8 9 q
HDBaseT Input
7
RS-232 3-pin Phoenix Connector
8
IR IN (to ELAN 5V 3.5mm IR receiver)
9
IR OUT (to ELAN 5V 3.5mm IR emitter)
q
HDMI Output - connect to HDMI on display
w
Optical Toslink audio output - Connects to local AV amplifier
e
and allows local HDMI audio breakout
Analog Audio Left / Right Output - 3.5mm stereo jack
r
de-embedded audio from HDMI input. Supports stereo 2ch
PCM audio only
12V/1A DC Power Input Screw Type Connector
t
RevA2_QRG_ELAN_EL-4KHDBT-RX-40-18G_PrintReady
QUICK REFERENCE GUIDE
12V 1A
HDMI OUT OPT OUT L/R OUT
w e r t
25/02/2022 11:12 25/02/2022 11:12