Table of Contents
Advertisement
OPTIONAL GAS LINE INSTALLATION
If you wish to install an unvented (vent-free)
gas log set, only unvented gas log sets which
have been found to comply with the standard
for unvented room heaters, ANSI Z21.11.2 are
to be installed in this fireplace.
WARNING: If the fireplace
has been used for wood burning,
the firebox and chimney must be
cleaned of soot, creosote and
ashes be a qualified chimney
cleaner. Creosote will ignite if
heavily heated.
1. The PureFire hood supplied with this fire-
place is packaged in a separate box and
placed in the firebox during shipping.
f i r e - p a r t s . c o m
2. Remove hood from box. Locate brackets
(quantity 2) and screws (quantity 4) for
hood installation in the hardware bag.
3. Using screws provided, secure the bracket
to the inner dome of the fireplace as shown
in Figure 28. The left and right bracket are
different. The edge that is straight will be
closer to the fireplace opening.
4. Lift hood up into the fireplace and place it
on the retaining brackets (Figure 28). The
rear of the hood will touching the rear of
the fireplace.
AIR DEFLECTOR AND GLASS DOOR INSTALLATION
INSTALLING AIR DEFLECTORS (42''
MODELS ONLY)
Slide air deflector in between the front side
face and side brick panel (see Figure 30, page
17). The notched end of the deflector sits on
bottom hearth. Air deflector does not require
any fastening.
The front side faces and side brick panels
will hold the deflector in place (see Figure
30, page 17).
WARNING: Do not slam or
strike doors. Damage can result
in a hazardous condition.
16
PUREFIRE HOOD INSTALLATION
www.SuperiorFireplaces.US.com
Continued
WARNING: When using a
decorative vented gas log, the
damper must be removed or
permanently locked in the fully
open position and the glass doors
must be in the fully open position.
Figure 28 - Installing PureFire Hood
DOOR FRAME MODELS
BDMO42/50E/G/C
Installation
1. Remove screws from smoke shelf (see
Figure 29, page 30).
2. Mount top door frame and secure with
screws provided (see Figure 29, page 17).
3. Place bottom door frame on top of ash lip
at front of fireplace (see Figure 30, page
17).
4. Secure bottom door frame to brick with
two hex screws provided as shown in
Figure 30, page 17 using a 7/16" open
end or adjustable wrench.
126598-01A
Advertisement
Table of Contents
