Motorola M800 User Manual page 112

Problem Solution
The beep indicates that you are set up correctly. If
I plugged the data cable
you did not hear a beep, make sure that both ends
into my phone but my
of the data cable are connected - the smaller end
phone did not beep. How
to your phone and the larger end to your computer.
do I know if the data cable
is ready to go?
Also, your computer may have deactivated the port
to save power. Try opening an application that
uses the port, like a fax or dial-up application, to
automatically activate the port.
You must be in an area with digital coverage.
My phone beeped when I
Check your phone's display for the digital signal
attached the data cable,
indicator (
but my data and fax
applications don't work. support data or fax transmission.
If you see the digital indicator, but you are roaming
on an unfamiliar network, this may be the case.
Also, remember that data and fax transmission
usually requires a subscription. Call your service
provider for more information.
19,200 Kbps is the data transfer rate of the
When sending data with
connection between your computer and the phone.
the data cable, why does
The rate of the connection between your phone
the computer show a
and the network is displayed on your phone, and
connection rate of 19,200
will be either 14400 or 9600 Kbps.
Kbps?
I can't end my data call by
Try pressing
closing the application on
turning off the phone. If possible, always close the
my computer. What can I
connection through your computer, as these
do?
alternative methods may disrupt the application on
your computer.
You may be in an area without service. If you have
I launched the micro-
wireless service, look in the display for the digital
browser but the display
says: Service Not signal indicator
Available.
indicator, you may be in an area that has only
analog service or no service at all. If you see the
digital signal indicator, you may be connected to a
digital network that does not support Internet
access.
Try again in a few minutes. The servers may be
I launched the micro-
temporarily busy.
browser but the display
says: Data Server
Unavailable.
110 - Troubleshooting
). Some wireless networks may not
. Or try disconnecting the cable or
. If you do not see the
( )