Setting Backlight Timer - Motorola iDEN i80s User Manual

Setting Backlight Timer

The backlight illuminates the display when you receive or make calls. You can
set the amount of time that the backlight stays on to 5, 10, 20, or 30 seconds, or
set it to stay on continuously or stay off at all times.
From the Initial Setup screen, press R to scroll to Backlight.
1
Press B under CHANGE.
2
Press S to scroll to the desired backlight option.
3
Press B under SELECT.
4
NOTE: Setting the backlight to stay on continuously will decrease the amount of time
you can use the phone before recharging the battery.Setting the backlight to
stay on continuously may degrade backlight brightness over time.
Setting Photo Sensor
NOTE: This is network subscription dependent feature. Please check with your
Service Provider for availability.
To conserve battery power, the photosensor will disable the backlight when you
are in good lighting conditions. To force the backlight to come on every time a
key is pressed, you can turn the photosensor off.
NOTE: Setting the Backlight to come on continuously while the Photosensor is
turned on will drain your battery power.
From the Initial Setup screen, press R to scroll to Sensor.
1
Press B under CHANGE.
2
Press S to scroll to the desired option.
3
Press B under SELECT.
4
Adjusting Status Light
The status light is located on the top of the phone. It illuminates when the phone
is on. See "Status of Your i 80s Phone" on page 27. You can turn the status light
feature on or off from the Initial Setup screen.
140
www.motorola.com/iden